In mailing-lists.linux-kernel, you wrote:
> I would like to know what is the current status (in the 2.4.x
> series) of the UDMA driver for the AMD760MP chipset.
One of the machines I am involved with has the Tyan Tiger MP 1.03
motherboard. It has a Maxtor 6L080J4 as the ide0 master, /dev/hda.
The stock 2.4.16 amd74xx driver defaults to UDMA2 on /dev/hda, and
with that configuration I get an hdparm -T of 21.40 MB/sec. The
ide0=ata66 kernel option successfully forces the drive and interface
to UDMA4, giving an hdparm -T of 38.1 MB/sec. I seem to recall that
without ide0=ata66, I was limited to UDMA2 (with hdparm -X), but I
can't verify that at this time.
The relevant boot messages from stock 2.4.16 with the ide0=ata66
kernel option are below. Note the message "hda: setting to mode 4,
driver problems in mode 5." That must be why I get UDMA4 instead of
UDMA5 in this configuration. But UDMA4 is plenty, I think; I have not
tried "hdparm -X69 /dev/hda".
I actually am usually running with Andre Hedrick's ATA patch (the
2001-11-24 version, I'm about to try the 2001-12-10 version). This is
because I have two PDC20268 cards (Promise Ultra100TX2), and the stock
kernel gives the "ERROR, PORT ADDRESSES ALREADY IN USE" messages below
for the second card. Then I can only do MDMA2 on the first PDC20268
and PIO on the second PDC20268. Ander Hedrick's ATA patch gives me
UDMA5 on all the interfaces.
Cheers,
Wayne
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
AMD7411: IDE controller on PCI bus 00 dev 39
AMD7411: chipset revision 1
AMD7411: not 100%% native mode: will probe irqs later
AMD7411: disabling single-word DMA support (revision < C4)
AMD7411: ATA-66/100 forced bit set (WARNING)!!
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
PDC20268: IDE controller on PCI bus 00 dev 48
PDC20268: chipset revision 1
PDC20268: not 100%% native mode: will probe irqs later
PDC20268: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary MASTER Mode.
ide2: BM-DMA at 0x1410-0x1417, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0x1418-0x141f, BIOS settings: hdg:pio, hdh:pio
PDC20268: IDE controller on PCI bus 00 dev 50
PDC20268: chipset revision 1
PDC20268: not 100%% native mode: will probe irqs later
PDC20268: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
ide4: BM-DMA at 0x1420-0x1427 -- ERROR, PORT ADDRESSES ALREADY IN USE
ide5: BM-DMA at 0x1428-0x142f -- ERROR, PORT ADDRESSES ALREADY IN USE
hda: MAXTOR 6L080J4, ATA DISK drive
hdc: OnStream ADR Series, ATAPI TAPE drive
hde: MAXTOR 6L080J4, ATA DISK drive
hdg: HL-DT-ST RW/DVD GCC-4120B, ATAPI CD/DVD-ROM drive
hdi: MAXTOR 6L080J4, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0x1448-0x144f,0x1442 on irq 10
ide3 at 0x1438-0x143f,0x1436 on irq 10
ide4 at 0x1460-0x1467,0x145a on irq 5
hda: setting to mode 4, driver problems in mode 5.
hda: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, UDMA(66)
hde: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, (U)DMA
hdi: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Dec 15 2001 - 21:00:21 EST