[PATCH V11 4/9] mfd: pm8008: Add reset-gpios

[Satya Priya]

Add the reset-gpio toggling in the pm8008_probe() to bring
pm8008 chip out of reset instead of doing it in DT node using
"output-high" property.

Signed-off-by: Satya Priya <quic_c_skakit@xxxxxxxxxxx>
---
Changes in V11:
 - Use local variable for reset_gpios as it is not used outside of probe.
 - Use GPIOD_OUT_LOW flag to initialize the gpio and remove below line
   as it is not required "gpiod_set_value(chip->reset_gpio, 1);".

Changes in V10:
 - This has been split from [V9,3/6] as per comments here [1]
  [1] https://patchwork.kernel.org/project/linux-arm-msm/patch/1649166633-25872-4-git-send-email-quic_c_skakit@xxxxxxxxxxx/#24803409

 drivers/mfd/qcom-pm8008.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/mfd/qcom-pm8008.c b/drivers/mfd/qcom-pm8008.c
index c472d7f..e7c3b32 100644
--- a/drivers/mfd/qcom-pm8008.c
+++ b/drivers/mfd/qcom-pm8008.c
@@ -4,6 +4,7 @@
  */
 
 #include <linux/bitops.h>
+#include <linux/gpio/consumer.h>
 #include <linux/i2c.h>
 #include <linux/interrupt.h>
 #include <linux/irq.h>
@@ -221,6 +222,7 @@ static int pm8008_probe(struct i2c_client *client)
 {
 	int rc;
 	struct pm8008_data *chip;
+	struct gpio_desc *reset_gpio;
 
 	chip = devm_kzalloc(&client->dev, sizeof(*chip), GFP_KERNEL);
 	if (!chip)
@@ -239,6 +241,10 @@ static int pm8008_probe(struct i2c_client *client)
 			dev_err(chip->dev, "Failed to probe irq periphs: %d\n", rc);
 	}
 
+	reset_gpio = devm_gpiod_get(chip->dev, "reset", GPIOD_OUT_LOW);
+	if (IS_ERR(reset_gpio))
+		return PTR_ERR(reset_gpio);
+
 	return devm_of_platform_populate(chip->dev);
 }
 
-- 
2.7.4