Re: [PATCH v4 2/2] MIPS: ingenic: Enable JZ4780_NEMC manually

[Paul Cercueil]

Le mar. 28 juil. 2020 à 14:00, Krzysztof Kozlowski <krzk@xxxxxxxxxx> a 
écrit :
> On Tue, Jul 28, 2020 at 01:37:02PM +0200, Thomas Bogendoerfer wrote:
> >  On Tue, Jul 28, 2020 at 01:19:35PM +0200, Krzysztof Kozlowski wrote:
> >  > On Tue, Jul 28, 2020 at 01:12:11PM +0200, Paul Cercueil wrote:
> >  > > Hi Krzysztof,
> >  > >
> >  > > Le mar. 28 juil. 2020 à 12:45, Krzysztof Kozlowski 
> > <krzk@xxxxxxxxxx> a écrit
> >  > > :
> >  > > > The CONFIG_JZ4780_NEMC was previously a default on MIPS but 
> > now it has
> >  > > > to be enabled manually.
> >  > > >
> >  > > > Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> >  > >
> >  > > I think you should swap the two so that there are no problems 
> > when
> >  > > bisecting.
> >  >
> >  > Good point. I was thinking that it will go via some of MIPS trees 
> > and
> >  > the patch #1 will just wait a cycle.  However with acks, I can 
> > take it
> >  > through drivers/memory tree.
> >
> >  I've acked the patch.
> >
> >  Thomas.
>
> Thanks but now I noticed that one of changed configs
> (arch/mips/configs/rs90_defconfig) is only in MIPS tree.
>
> I think it is easier then to take the patch #2 (configs) via MIPS and
> wait with #1 for the next cycle or also take it via MIPS if it applies
> cleanly.

Why not take them both in the MIPS tree then? Would that conflict with 
changes in your tree?

-Paul