Re: [PATCH v4 2/2] MIPS: ingenic: Enable JZ4780_NEMC manually

[Krzysztof Kozlowski]

On Tue, Jul 28, 2020 at 01:37:02PM +0200, Thomas Bogendoerfer wrote:
> On Tue, Jul 28, 2020 at 01:19:35PM +0200, Krzysztof Kozlowski wrote:
> > On Tue, Jul 28, 2020 at 01:12:11PM +0200, Paul Cercueil wrote:
> > > Hi Krzysztof,
> > > 
> > > Le mar. 28 juil. 2020 Ã 12:45, Krzysztof Kozlowski <krzk@xxxxxxxxxx> a Ãcrit
> > > :
> > > > The CONFIG_JZ4780_NEMC was previously a default on MIPS but now it has
> > > > to be enabled manually.
> > > > 
> > > > Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
> > > 
> > > I think you should swap the two so that there are no problems when
> > > bisecting.
> > 
> > Good point. I was thinking that it will go via some of MIPS trees and
> > the patch #1 will just wait a cycle.  However with acks, I can take it
> > through drivers/memory tree.
> 
> I've acked the patch.
> 
> Thomas.

Thanks but now I noticed that one of changed configs
(arch/mips/configs/rs90_defconfig) is only in MIPS tree.

I think it is easier then to take the patch #2 (configs) via MIPS and
wait with #1 for the next cycle or also take it via MIPS if it applies
cleanly.

Best regards,
Krzysztof