Re: [PATCH v2 2/8] arm64: dts: qcom: pm8150: Add Base DTS file
From: Vinod Koul
Date: Tue Aug 20 2019 - 08:35:57 EST
On 20-08-19, 14:27, Niklas Cassel wrote:
> On Tue, Aug 20, 2019 at 12:12:10PM +0530, Vinod Koul wrote:
> > Add base DTS file for pm8150 along with GPIOs, power-on, rtc and vadc
> > nodes
> >
> > Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> > ---
> > arch/arm64/boot/dts/qcom/pm8150.dtsi | 95 ++++++++++++++++++++++++++++
> > 1 file changed, 95 insertions(+)
> > create mode 100644 arch/arm64/boot/dts/qcom/pm8150.dtsi
> >
> > diff --git a/arch/arm64/boot/dts/qcom/pm8150.dtsi b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> > new file mode 100644
> > index 000000000000..4a678be46d37
> > --- /dev/null
> > +++ b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> > @@ -0,0 +1,95 @@
> > +// SPDX-License-Identifier: BSD-3-Clause
> > +// Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
> > +// Copyright (c) 2019, Linaro Limited
> > +
> > +#include <dt-bindings/input/input.h>
> > +#include <dt-bindings/interrupt-controller/irq.h>
> > +#include <dt-bindings/spmi/spmi.h>
> > +#include <dt-bindings/iio/qcom,spmi-vadc.h>
> > +
> > +&spmi_bus {
> > + pm8150_0: pmic@0 {
> > + compatible = "qcom,pm8150", "qcom,spmi-pmic";
> > + reg = <0x0 SPMI_USID>;
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > +
> > + pon: power-on@800 {
> > + compatible = "qcom,pm8916-pon";
> > + reg = <0x0800>;
> > + pwrkey {
> > + compatible = "qcom,pm8941-pwrkey";
> > + interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
>
> Here you use 0 for 3rd cell
>
> > + debounce = <15625>;
> > + bias-pull-up;
> > + linux,code = <KEY_POWER>;
> > +
> > + status = "disabled";
> > + };
> > + };
> > +
> > + pm8150_adc: adc@3100 {
> > + compatible = "qcom,spmi-adc5";
> > + reg = <0x3100>;
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > + #io-channel-cells = <1>;
> > + interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
>
> Here you use 0x0 for 3rd cell, be consistent.
Will make it either at this and other places, thanks for pointing!
--
~Vinod