Re: N900 DT

[Pali RohÃr]

On Saturday 26 October 2013 02:25:02 Sebastian Reichel wrote:
> Hi Pali,
> 
> On Fri, Oct 25, 2013 at 08:39:40PM +0200, Pali RohÃr wrote:
> > Now I found this patch and it looks like it will be in
> > mainline kernel. And after that it could be simple to
> > listen for needed events from isp driver in my bq driver
> > (without touching isp).
> > 
> > https://lkml.org/lkml/2013/7/25/204
> > 
> > Can you look at isp1704 driver for DT support? I think that
> > only one gpio needs to be passed to driver from board data.
> 
> I had a quick overview over Jenny's patchset [0] (the patch
> you referenced is part of a bigger patchset). I don't think
> the scenario found in the Nokia N900 is covered by it, but
> probably now is the time to change it :)
> 
> So for everybody new to this thread:
> 
> Multiple chips are involved in the charging of the Nokia N900
> battery:
> 
> bq27200:   This chip is used for reading battery status. AFAIK
>            it's not directly involved in charging the battery.
> bq24150a:  This chip takes care of actually charging the
> battery. It has no clue about USB related stuff. The maximum
> current it draws can be configured, though. isp1704:   USB
> charger detector. This chip is used to detect how much
> current may be used by the bq24150a chip. rx51-temp: Analog
> temperature sensor for the battery, which is connected via an
> analog-digital-converter.
> 
> The question is how to connected these driver with each other
> if device tree is used to boot the system. Any suggestions?
> 
> [0] http://thread.gmane.org/gmane.linux.kernel/1377608
> 
> -- Sebastian

What I need is receive property change event (from isp1704) in 
bq24150a. And with this patch https://lkml.org/lkml/2013/7/25/204 
bq24150a driver can receive them and use only these which comes 
from driver specified in DT (on n900 from isp1704).

-- 
Pali RohÃr
pali.rohar@xxxxxxxxx

Attachment: signature.asc
Description: This is a digitally signed message part.