On 9/10/2013 2:47 PM, Laxman Dewangan wrote:On Tuesday 10 September 2013 01:19 PM, George Cherian wrote:Correct extcon should just notify and the consumer should takeIn OMAP5 when USB-HOST is set true, the VBUS regulator is turned ON.Should we really handle this on this extcon driver? I think it should
This causes a VBUS interrupt, ignore the same if we are already in
USB-HOST.
Signed-off-by: George Cherian <george.cherian@xxxxxx>
---
drivers/extcon/extcon-palmas.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/extcon/extcon-palmas.c
b/drivers/extcon/extcon-palmas.c
index 9672f31..91b31af 100644
--- a/drivers/extcon/extcon-palmas.c
+++ b/drivers/extcon/extcon-palmas.c
@@ -50,6 +50,9 @@ static irqreturn_t palmas_vbus_irq_handler(int irq,
void *_palmas_usb)
struct palmas_usb *palmas_usb = _palmas_usb;
unsigned int vbus_line_state;
+ if (palmas_usb->linkstat == PALMAS_USB_STATE_ID)
+ return IRQ_HANDLED;
+
be handled in the USB driver. If port is OTG type and if usb driver
enable the VBUS then it can expect the VBUS available notification but
based on the USB driver state, it should ignore this notification.
appropriate decision.
Otherwise, Palmas pin find that there is VBUS state true but the SW
status will show as the VBUS not there.