[PATCH 3/3 RESEND] mmc: sdhci: check voltage range only on regulatorsaware of voltage value

[Marek Szyprowski]

Some regulators don't report any voltage values, so checking supported
voltage range results in disabling all SDHCI_CAN_VDD_* flags and
registration failure. This patch finally provides a correct fix for the
registration of SDHCI driver with all possible voltage regulators:
dummy, fixed and regulated without using regulator_count_voltages()
hacks.

Signed-off-by: Marek Szyprowski <m.szyprowski@xxxxxxxxxxx>
---
 drivers/mmc/host/sdhci.c |    6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index ba586ae..735526b 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2976,7 +2976,11 @@ int sdhci_add_host(struct sdhci_host *host)
 	}
 
 #ifdef CONFIG_REGULATOR
-	if (host->vmmc) {
+	/*
+	 * Voltage range check makes sense only if regulator reports
+	 * any voltage value.
+	 */
+	if (host->vmmc && regulator_get_voltage(host->vmmc) > 0) {
 		ret = regulator_is_supported_voltage(host->vmmc, 2700000,
 			3600000);
 		if ((ret <= 0) || (!(caps[0] & SDHCI_CAN_VDD_330)))
-- 
1.7.9.5

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/