Re: kgdb errors with serial console

[Elvis Dowson]

Hi Jason,

On Oct 8, 2010, at 2:37 AM, Jason Wessel wrote:

> It would probably also be good to test if the debugger is working at all
> on your serial port.
> 
> Configure the debugger with:
> # echo ttyS2 > /sys/module/kgdboc/parameters/kgdboc
> kgdb: Registered I/O driver kgdboc.
> # echo g > /proc/sysrq-trigger
> SysRq : DEBUG
> 
> And now to exit debugger you must blindly and perfectly type
> $D#44+
> 
> Nothing will be echoed because at this stage the kernel serial polling
> driver would just be collecting characters.
> 
> After typing that the kernel should return back to the running state and
> print something like:
> +$OK#9a#

Cool, I tried all the commands that you suggested and it worked perfectly. I got the same outputs. 

So, if I understand correctly, I boot into the kernel without the kgbdwait option, and then manually launch the kgdb and then connect from Eclipse using gdb.

The system waits at the root login prompt. 

Just so that I can see some quick results, can you suggest which file I could set a break point into, and monitor the registers and variable states at this stage, i.e. immediately after the root login?

Best regards,

Elvis

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/