Re: [patch 2.6.13-rc3] sis190 driver

From: Pascal CHAPPERON
Date: Sat Jul 30 2005 - 06:13:20 EST


> Message du 30/07/05 12:13
> De : "Francois Romieu" <romieu@xxxxxxxxxxxxx>
[...]
> Lars noticed that the link status is not correctly reported and suggested
> a few changes. Can you check if the version below works better ?
>
I was precisely modifying mii_chip_table[] in sis190-120 to make it work ;-)

Yes, that new version works well.

#dmesg
sis190 Gigabit Ethernet driver 1.2 loaded.
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:00:04.0 to 64
0000:00:04.0: Read MAC address from APC.
eth0: Realtek PHY RTL8201 transceiver at address 1.
eth0: Using transceiver at address 1 as default.
0000:00:04.0: sis190 at ffffc20000004c00 (IRQ: 11), 00:11:2f:e9:42:70
eth0: Enabling Auto-negotiation.
eth0: mii ext = 0000.
eth0: mii lpa = c1e1 adv = 01e1.
eth0: link on 100 Mbps Full Duplex mode.

By the way, i still can not force speed/mode/autoneg (ethtool or mii-tool);
ethtool reports correctly the changes, but autoneg is not really disabled,
and the driver falls back to 100 Full...

Had Lars better results with autoneg off?

-
Pascal

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/