Re: [patch 2.6.13-rc3] sis190 driver

From: Pascal CHAPPERON
Date: Sat Jul 30 2005 - 04:34:12 EST

> Message du 29/07/05 00:13
> De : "Francois Romieu" <romieu@xxxxxxxxxxxxx>

> Changes from previous version (20050722)
> o Minor round of mii/phy related changes. May crash.
> Testing reports/review/patches are always appreciated.

sis190-120 compiles, loads but does not work (sis190_init_phy() function).

# service network start
Bringing up loopback interface: [ OK ]
Bringing up interface eth0:
Determining IP information for eth0... failed; no link present. Check cable?

sis190 Gigabit Ethernet driver 1.2 loaded.
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:00:04.0 to 64
0000:00:04.0: Read MAC address from APC.
eth0: Unknown PHY transceiver at address 1.
0000:00:04.0: sis190 at ffffc20000004c00 (IRQ: 11), 00:11:2f:e9:42:70
eth0: Enabling Auto-negotiation.

# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000037 (55)
Link detected: no

I reverted to sis190-110, which works well on my box.


To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at
Please read the FAQ at