On Tue, 6 Jun 2000 scoetzee@voltex.co.za wrote:
my squid box with a 3c59x vortex aslo have this problem....
Rodel
> Hi,
> I decided to download and test 2.4, and I came across an odd problem.
>
>
> I **don't need a fix** for this, I just thought it should be looked at for the
> final release,
> as it could pose a problem. If there is anything I can do to narrow down the
> fault,
> let me know.
>
>
> My configuration is :
> PII-400
> Voodoo3 3000
> sblive value
> 3com 3c59x vortex
> gigabyte ga6bxds m/board
>
> when I boot 2.4 everything is fine, then I load modules for everything, fine.
> but then the 3com card either stops working or drops down to 10Meg.
> this happens after about 20 minutes, using heavy ftp load, via a 100Meg
> crossover cable to another
> linux box running 2.2.5 with an eepro100.
> twice out of the ten times I tried to remove and reinsert the module 3c59x it
> started working again, but only
> at 10 meg.
> all of this works fine under 2.2.14 , so there isn't any hardware problems.
> Also, I get no errors anywhere.
>
>
> Stef
>
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.rutgers.edu
> Please read the FAQ at http://www.tux.org/lkml/
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Jun 07 2000 - 21:00:27 EST