Hate to bug all the busy folks out there again, but this problem still
persists... I tried it on another system and same thing...
Brendan
On Wed, Feb 02, 2000 at 01:37:02PM -0800, Brendan Miller wrote:
>
> I built a 2.2.14 + ide.2.2.14.20000124.patch kernel with HPT366 support.
> I thought this was the right thing to do. :)
>
> When I went to boot the new kernel, it locked up right after
> "Loading linux-hpt366..."
>
> The machine is a Micronics M54Pe (dual P133). I am using an Abit HotRod 66.
> The machine has onboard IDE -- primary is CMD640, secondary is "run of the
> mill" ISA (it's on the motherboard, but the kernel just detects normal
> ide driver, as opposed to the special CMD640 driver). These two interfaces
> get IRQ 14 and 15 under normal circumstances.
>
> I thought that the HPT366 would get a different IRQ and be assigned ide2
> and ide3. When I boot a non-hpt366 kernel, /proc/pci shows that the
> HPT366 (Triones Technology) gets IRQ11 for both interfaces.
>
> Connected to the HPT366 is a Maxtor 90845D4 (8.4G UDMA drive). I believe
> this drive only supports UMDA/33 Mode 2, but I wanted to test the controller
> under Linux first.
>
> Did I do everything correct?
>
> Is it time to jump into 2.3.xx fun?
>
> Brendan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Feb 07 2000 - 21:00:14 EST