0. The Makefile still says it is 2.3.18.
1. The line 72 of drivers/char/Config.in still needs a ']'
2. On Compaq Proliant 1600 (dual PII/400) it still does not boot. See
bootlog captured via serial console below with SMP_DEBUG on. Note that
2.3.14 and earlier work fine.
Regards,
------
Tigran A. Aivazian | http://www.sco.com
Escalations Research Group | tel: +44-(0)1923-813796
Santa Cruz Operation Ltd | http://www.ocston.org/~tigran
Linux version 2.3.18 (root@elisha.london.sco.com) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 SMP Fri Oct 1 09:21:48 BST 1999
e820: 653312 @ 00000000 (usable)
e820: 2048 @ 0009f800 (reserved)
e820: 65536 @ 000f0000 (reserved)
e820: 66060288 @ 00100000 (usable)
e820: 65536 @ fec00000 (reserved)
e820: 65536 @ fee00000 (reserved)
e820: 524288 @ fff80000 (reserved)
e820: 0 @ 00000000 (usable)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Intel MultiProcessor Specification v1.4
Virtual Wire compatibility mode.
OEM ID: COMPAQ Product ID: PROLIANT APIC at: 0xFEE00000
Processor #1 Pentium(tm) Pro APIC version 16
Floating point unit present.
Machine Exception supported.
64 bit compare & exchange supported.
Internal APIC present.
Bootup CPU
Processor #0 Pentium(tm) Pro APIC version 16
Floating point unit present.
Machine Exception supported.
64 bit compare & exchange supported.
Internal APIC present.
Bus #0 is PCI
Bus #1 is PCI
Bus #9 is ISA
I/O APIC #8 Version 17 at 0xFEC00000.
Processors: 2
mapped APIC to ffffe000 (fee00000)
mapped IOAPIC to ffffd000 (fec00000)
Detected 399076003 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 398.13 BogoMIPS
memory region: 638k @ 00000000
memory region: 64512k @ 00100000
Memory: 62824k/65536k available (872k kernel code, 432k reserved, 1328k data, 80k init, 0k bigmem)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35 (19990512) Richard Gooch (rgooch@atnf.csiro.au)
per-CPU timeslice cutoff: 100.01 usecs.
CPU1: Intel Pentium II (Deschutes) stepping 01
Getting VERSION: 40011
Getting VERSION: 40011
Getting LVT0: 700
Getting LVT1: 400
setup_APIC_clock() called.
calibrating APIC timer ...
..... 3990924 CPU clocks in 1 timer chip tick.
.... 997729 APIC bus clocks in 1 timer chip tick.
..... CPU clock speed is 399.0924 MHz.
..... system bus clock speed is 99.7729 MHz.
CPU map: 3
Booting processor 0 eip 2000
Setting warm reset code and vector.
1.
2.
3.
Asserting INIT.
Deasserting INIT.
Sending STARTUP #1.
After apic_write.
Before start apic_write.
Startup point 1.
Initializing CPU#0
Waiting for send to finish...
CPU#0 waiting for CALLOUT
+Sending STARTUP #2.
After apic_write.
Before start apic_write.
Startup point 1.
Waiting for send to finish...
+After Startup.
Before Callout 0.
After Callout 0.
CALLIN, before enable_local_APIC().
setup_APIC_clock() called.
waiting for other CPU calibrating APIC ... done, continuing.
Calibrating delay loop... 398.95 BogoMIPS
Stack at about c0343fbc
OK.
CPU0: Intel Pentium II (Deschutes) stepping 01
CPU has booted.
Before bogomips.
Total of 2 processors activated (797.08 BogoMIPS).
Before bogocount - setting activated=1.
Boot done.
enabling symmetric IO mode... ...done.
ENABLING IO-APIC IRQs
init IO_APIC IRQs
IO-APIC (apicid-pin) 8-0, 8-16, 8-17, 8-18, 8-19, 8-20, 8-21, 8-22, 8-23, 8-24, 8-25, 8-26, 8-27, 8-28, 8-29, 8-30, 8-31, 8-32, 8-33, 8-34 not connected.
number of MP IRQ sources: 16.
number of IO-APIC #8 registers: 35.
testing the IO APIC.......................
IO APIC #8......
.... register #00: 00000000
....... : physical APIC id: 00
.... register #01: 00220011
...... : max redirection entries: 0022
WARNING: unexpected IO-APIC, please mail
to linux-smp@vger.rutgers.edu
....... : IO APIC version: 0011
.... register #02: 00000000
....... : arbitration: 00
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00
01 000 00 0 0 0 0 0 1 1 59
02 0FF 0F 0 0 0 0 0 1 1 51
03 000 00 0 0 0 0 0 1 1 61
04 000 00 0 0 0 0 0 1 1 69
05 0FF 0F 1 1 0 0 0 1 1 71
06 000 00 0 0 0 0 0 1 1 79
07 000 00 0 0 0 0 0 1 1 81
08 000 00 0 0 0 0 0 1 1 89
09 0FF 0F 1 1 0 0 0 1 1 91
0a 0FF 0F 1 1 0 0 0 1 1 99
0b 0FF 0F 1 1 0 0 0 1 1 A1
0c 000 00 0 0 0 0 0 1 1 A9
0d 000 00 1 0 0 0 0 0 0 00
0e 000 00 0 0 0 0 0 1 1 B1
0f 0FF 0F 1 1 0 0 0 1 1 B9
10 000 00 1 0 0 0 0 0 0 00
11 000 00 1 0 0 0 0 0 0 00
12 000 00 1 0 0 0 0 0 0 00
13 000 00 1 0 0 0 0 0 0 00
14 000 00 1 0 0 0 0 0 0 00
15 000 00 1 0 0 0 0 0 0 00
16 000 00 1 0 0 0 0 0 0 00
17 000 00 1 0 0 0 0 0 0 00
18 000 00 1 0 0 0 0 0 0 00
19 000 00 1 0 0 0 0 0 0 00
1a 000 00 1 0 0 0 0 0 0 00
1b 000 00 1 0 0 0 0 0 0 00
1c 000 00 1 0 0 0 0 0 0 00
1d 000 00 1 0 0 0 0 0 0 00
1e 000 00 1 0 0 0 0 0 0 00
1f 000 00 1 0 0 0 0 0 0 00
20 000 00 1 0 0 0 0 0 0 00
21 000 00 1 0 0 0 0 0 0 00
22 000 00 1 0 0 0 0 0 0 00
.................................... done.
Initializing CPU#1
Setting commenced=1, go go go
mtrr: your CPUs had inconsistent fixed MTRR settings
mtrr: probably your BIOS does not setup all CPUs
PCI: PCI BIOS revision 2.10 entry at 0xf0080
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Assigned I/O space 1000-101f to device Intel 82371AB PIIX4 USB
PCI: Enabling I/O for device Intel 82371AB PIIX4 USB
PCI: Device 00:00 not found by BIOS
PCI: Device 00:a0 not found by BIOS
PCI: Device 00:a1 not found by BIOS
PCI: Device 00:a2 not found by BIOS
PCI: Device 00:a3 not found by BIOS
Linux NET4.0 for Linux 2.3
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (established 2048 bind 4096)
Starting kswapd v1.6
Detected PS/2 Mouse Port.
Ser
on the real console I see the end of the last sentence as well, i.e.
"Serial driver version 4.30 with_"
(I showed blinking cursor as _)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/