Timothy,
Fresh Install of Slackware 3.6
SuperMicro P6SBA mobo with AMI winBIOS (nolaughing) 1.5b (latest)
PII 350
128MB PC100 SDRAM
IBM 1.6GB IDE - primary slave
Maxtor 7GB IDE - primary master
Teac 32X CDrom - secondary master
Mitsumi 32X CDrom - seconadry slave
3com 3c509B (no problems until new mobo)
STB V4400 Pci
gen Pci soundcard with Vortex1 chipset
33.6 modem ISA
Linux version 2.2.6 (root@ziggy) (gcc version 2.7.2.3) #7 Wed Apr 28
21:04:51 EDT 1999
Detected 350804336 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 349.80 BogoMIPS
Memory: 128220k/131072k available (888k kernel code, 412k reserved,
1516k data, 36k init)
CPU: Intel Pentium II (Deschutes) stepping 01
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.26 (19981001) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfdb81
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Enabling I/O for device 00:3a
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 90720D5, ATA DISK drive
hdb: IBM-DJAA-31700, ATA DISK drive
hdc: CD-532E-A, ATAPI CDROM drive
hdd: FX320S, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: Maxtor 90720D5, 6869MB w/256kB Cache, CHS=875/255/63, UDMA
hdb: IBM-DJAA-31700, 1628MB w/96kB Cache, CHS=827/64/63, DMA
hdc: ATAPI 32X CD-ROM drive, 128kB Cache
Uniform CDROM driver Revision: 2.54
hdd: ATAPI 32X CD-ROM drive, 256kB Cache
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
PPP: version 2.3.3 (demand dialling)
TCP compression code copyright 1989 Regents of the University of
California
PPP line discipline registered.
eth0: 3c509 at 0x280 tag 1, 10baseT port, address 00 a0 24 1f 32 02,
IRQ 9.
3c509.c:1.16 (2.2) 2/3/98 becker@cesdis.gsfc.nasa.gov.
Partition check:
hda: hda1 hda2 hda3
hdb: hdb1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 36k freed
eth0: Setting Rx mode to 1 addresses.
eth0 Link encap:Ethernet HWaddr 00:A0:24:1F:32:02
inet addr:10.0.10.75 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9 Base address:0x280
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:40 errors:0 dropped:0 overruns:0 frame:0
TX packets:40 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
CPU0
0: 5367 XT-PIC timer
1: 282 XT-PIC keyboard
2: 0 XT-PIC cascade
8: 1 XT-PIC rtc
9: 0 XT-PIC eth0
12: 0 XT-PIC PS/2 Mouse
13: 1 XT-PIC fpu
14: 1723 XT-PIC ide0
15: 12 XT-PIC ide1
NMI: 0
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.0.0.0 10.0.10.75 255.0.0.0 UG 0 0 0
eth0
10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
eth0
10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
lo
0.0.0.0 10.0.0.1 0.0.0.0 UG 1 0 0
eth0
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/