Perhaps it is only a one liner, but the bttv modules for the Hauppauge
WinTV are crashing the whole computer 1 or 2 seconds after insmoding
bttv.o (alt+sysreq+b for reboot works, no log entries). This is true
for the bttv drivers from xawtv-2.32 as for the ones included in the
kernel source.
Kernel Version 2.2-pre7 and a lot of previous kernels worked really
fine together with the bttv driver from xawtv-2.32. No hangs, no
crashes, everything worked just great.
My setup:
Computer: Dual P100 on a Tyan Tomcat II (430HX), SMP Kernel.
Rest of hardware: Ethernet controller DEC 21143, Matrox Millenium I,
Adaptec 2940 with 4 devices/2 disk drives, Soundblaster
AWE32. Interrupt configuration is:
CPU0 CPU1
0: 349215 0 XT-PIC timer
1: 5794 5833 IO-APIC-edge keyboard
2: 0 0 XT-PIC cascade
4: 19596 19630 IO-APIC-edge serial
7: 628 636 IO-APIC-edge soundblaster
8: 2 0 IO-APIC-edge rtc
10: 3721 3636 IO-APIC-level aic7xxx
12: 85487 86975 IO-APIC-level bttv
13: 1 0 XT-PIC fpu
15: 12900 13495 IO-APIC-level DC21143 (eth0)
On 2.2-pre7 the modules say during insmod:
Linux video capture interface: v0.01 ALPHA
i2c: initialized
i2c: driver registered: tuner
i2c: driver registered: msp3400
bttv0: Brooktree Bt848 (rev 17) bus: 0, devfn: 136, irq: 12, memory:
0xe2000000.
bttv: 1 Bt8xx card(s) found.
bttv0: Hauppauge eeprom: tuner=Phillips FM1216 (5)
bttv0: model: BT848(Hauppauge old)
i2c: bus registered: bt848-0
i2c: device attached: tuner (addr=0xc2, bus=bt848-0, driver=tuner)
msp3400: init: chip=MSP3400C-C6
i2c: device attached: MSP3400C-C6 (addr=0x80, bus=bt848-0, driver=msp3400)
Perhaps someone has the same problem with 2.2-final and a Hauppauge
WinTV board?
Regards
Carsten Gross
-- What happens if a big asteroid hits Earth? Judging from simulations involving a sledge hammer and a laboratory frog, we can assume it will be pretty bad. Carsten Gross carsten@sol.wohnheim.uni-ulm.de Wohnheim Heilmeyersteige Sebastian Kneipp Weg 6, 89075 Ulm
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/