printer as module w/ pre5

Jean-Marc.Valin (valj01@gel.usherb.ca)
Thu, 7 Jan 1999 21:59:29 -0500 (EST)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Stephen Williams: "Re: C++ in kernel (was Re: exception in a device driver)"
Previous message: David B. Rees: "v.90 tulip driver?"

I get the "/dev/lp0: Device not configured" error when trying to acces my
printer when the lp and parport are built as modules, but everything works
fine when their built in the kernel. Also, lsmod tells me that both
parport and lp are loaded. (Config: PPro 180 / 64MB / RH 5.2) I also had
that problem with pre4, but not the 2.0 series.

Jean-Marc Valin

-------------------------------------------------------------------------
Jean-Marc Valin O'TOOL'S COMMENTARY ON MURPHY'S LAWS
valj01@gel.usherb.ca -Murphy was an optimist

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

Next message: Stephen Williams: "Re: C++ in kernel (was Re: exception in a device driver)"
Previous message: David B. Rees: "v.90 tulip driver?"