> I have a computer that has 2 Intel EEPro100 Ethernet cards and an
> Adaptec 2940 SCSI controller on the PCI bus. The bios
> unfortunately provides no way to hard code the interupts on any of
> the devices, and procedes to allocate them in the following
> fashion: [notice shared int 10]
Most BIOSes don't give you much control over this stuff... you can
try marking the IRQ reserved for non-ISA pnp or whatever your bios
calls it and it will move the cards resorces elsewhere. Over several
boots you can juggle them about a little...
[...]
> This output was produced under 2.0.36. I have been unable to get
> the machine to boot under 2.2pre4.
What does it do under 2.2pre4 then? Have you tried pre4-ac4?
-cw
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/