mkinitrd /boot/initrd.img 2.0.36and then put initrd in you /etc/lilo.conf too :
initrd=/boot/initrd.img
and rerun lilo
and depending on which SCSI adapter you're using, but for me (i use an ADAPTEC
AICxxx ) i put in /etc/conf.modules : alias scsi_hostadapter aicxxx
and everything works fine
well perhaps, you could try all that.
> >>>> "Patrick" == Patrick Maillé <p-maille@pci.fr> writes:
> > Did you use initrd, to load your scsi module on boot up ?
>
> Nope, no initrd of any kind.
> And other modules get loaded just fine.
> And no, I didn't put anything in /etc/modules.conf about that either
> because (1) I've never had to and (2) I assume should get error messages from
> kerneld if such an entry was missing.
>
> Stefan
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.rutgers.edu
> Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/