300mhz PII, Asus LX6 w/built-in Adaptec-7880, WD Scsi drive, SMC
EtherPower II running at 10baseT.
Enjoy,
Pete Harlan
harlan@pointofchoice.com
Gory Details:
CONFIG_MODULES=y
CONFIG_NET=y
CONFIG_PCI=y
CONFIG_SYSVIPC=y
CONFIG_BINFMT_AOUT=y
CONFIG_BINFMT_ELF=y
CONFIG_KERNEL_ELF=y
CONFIG_M686=y
CONFIG_BLK_DEV_FD=y
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_TRITON=y
CONFIG_INET=y
CONFIG_SYN_COOKIES=y
CONFIG_IP_NOSR=y
CONFIG_SKB_LARGE=y
CONFIG_SCSI=y
CONFIG_BLK_DEV_SD=y
CONFIG_SCSI_AIC7XXX=y
CONFIG_OVERRIDE_CMDS=y
CONFIG_NETDEVICES=y
CONFIG_NET_ETHERNET=y
CONFIG_NET_PCI=y
CONFIG_EPIC=y
CONFIG_EXT2_FS=y
CONFIG_PROC_FS=y
Linux version 2.0.35 (root@www) (gcc version 2.7.2.1) #1 Wed Jul 15
17:50:04 CDT 1998
Starting kswapd v 1.4.2.2
ide: i82371 PIIX (Triton) on PCI bus 0 function 33
ide0: BM-DMA at 0xd800-0xd807
hda: QUANTUM Bigfoot TX8.0AT, 7665MB w/69kB Cache, CHS=15574/16/63,
UDMA
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
(scsi0) <Adaptec AIC-7880 Ultra SCSI host adapter> found at PCI 6/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) BIOS enabled, IO Port 0xd000, IRQ 12
(scsi0) IO Memory at 0xe3000000, MMAP Memory at 0x4805000
(scsi0) Resetting channel
(scsi0) Downloading sequencer code... 406 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI)
5.0.19/3.2.4
<Adaptec AIC-7880 Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:-1:-1) Scanning channel for devices.
Vendor: WDIGTL Model: ENTERPRISE Rev: 1.91
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi : detected 1 SCSI disk total.
(scsi0:0:0:0) Using wide (16 bit) transfers.
(scsi0:0:0:0) Synchronous at 10.0MHz, offset 8.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8515173 [4157 MB]
[4.2 GB]
epic100.c:v0.99B 4/7/98 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/epic100.html
eth0: SMC EPIC/100 at 0xb800, IRQ 10, 00:e0:29:0f:dc:66.
eth0: MII transceiver found at address 3.
PCI latency timer (CFLT) value of 0 is unreasonably low, setting to
32.
Partition check:
sda: sda1 sda2 sda3
hda: hda1 hda2
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 120480k swap-space (priority -1)
kill_fasync: bad magic number in fasync_struct!
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.altern.org/andrebalsa/doc/lkml-faq.html