Regards,
Richard....
23:32:15 Linux version 2.1.102 (rgooch@workaholix) (gcc version 2.7.2.f.1) #1 SMP Sun 23:11:41 EST 1998
23:32:15 Intel MultiProcessor Specification v1.1
23:32:15 Virtual Wire compatibility mode.
23:32:15 OEM ID: OEM00000 Product ID: PROD00000000 APIC at: 0xFEE00000
23:32:15 Processor #1 Pentium(tm) Pro APIC version 17
23:32:15 Processor #0 Pentium(tm) Pro APIC version 17
23:32:15 I/O APIC #2 Version 17 at 0xFEC00000.
23:32:15 Processors: 2
23:32:15 Console: 8 point font, 400 scans
23:32:15 Console: colour VGA+ 80x50, 1 virtual console (max 63)
23:32:15 Calibrating delay loop... 179.40 BogoMIPS
23:32:15 Memory: 128152k/131072k available (732k kernel code, 400k reserved, 1732k data, 56k init)
23:32:15 Swansea University Computer Society NET3.039 for Linux 2.1
23:32:15 NET3: Unix domain sockets 0.16 for Linux NET3.038.
23:32:15 Swansea University Computer Society TCP/IP for NET3.037
23:32:15 IP Protocols: ICMP, UDP, TCP
23:32:15 Checking 386/387 coupling... Ok, fpu using exception 16 error reporting.
23:32:15 Checking 'hlt' instruction... Ok.
23:32:15 POSIX conformance testing by UNIFIX
23:32:15 mtrr: v1.20 (19980502) Richard Gooch (rgooch@atnf.csiro.au)
23:32:15 CPU1: Intel Pentium Pro stepping 09
23:32:16 calibrating APIC timer ...
23:32:16 ..... CPU clock speed is 179.6341 MHz.
23:32:16 ..... APIC bus clock speed is 59.8777 MHz.
23:32:16 Booting processor 0 eip 2000
23:32:16 Calibrating delay loop... 179.40 BogoMIPS
23:32:16 OK.
23:32:16 CPU0: Intel Pentium Pro stepping 09
23:32:16 Total of 2 processors activated (358.81 BogoMIPS).
23:32:16 enabling Symmetric IO mode ... ...done.
23:32:16 ENABLING IO-APIC IRQs
23:32:16 init IO_APIC IRQs
23:32:16 IO-APIC pin 0, 20, 21, 22, 23 not connected.
23:32:16 nr of MP irq sources: 21.
23:32:16 nr of IO-APIC registers: 24.
23:32:16 testing the IO APIC.......................
23:32:16 .... register #00: 00000000
23:32:16 ....... : physical APIC id: 00
23:32:16 .... register #01: 00170011
23:32:16 ....... : max redirection entries: 0017
23:32:16 ....... : IO APIC version: 0011
23:32:16 .... register #02: 00000000
23:32:16 ....... : arbitration: 00
23:32:16 .... IRQ redirection table:
23:32:16 NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
23:32:16 00 000 00 1 0 0 0 0 0 0 00
23:32:16 01 0FF 0F 0 0 0 0 0 1 1 59
23:32:16 02 0FF 0F 0 0 0 0 0 1 1 51
23:32:16 03 0FF 0F 0 0 0 0 0 1 1 69
23:32:16 04 0FF 0F 0 0 0 0 0 1 1 71
23:32:16 05 0FF 0F 0 0 0 0 0 1 1 79
23:32:16 06 0FF 0F 0 0 0 0 0 1 1 81
23:32:16 07 0FF 0F 0 0 0 0 0 1 1 89
23:32:16 08 0FF 0F 0 0 0 0 0 1 1 91
23:32:16 09 0FF 0F 0 0 0 0 0 1 1 99
23:32:16 0a 0FF 0F 0 0 0 0 0 1 1 A1
23:32:16 0b 0FF 0F 0 0 0 0 0 1 1 A9
23:32:16 0c 0FF 0F 0 0 0 0 0 1 1 B1
23:32:16 0d 000 00 1 0 0 0 0 0 0 00
23:32:16 0e 0FF 0F 0 0 0 0 0 1 1 C1
23:32:16 0f 0FF 0F 0 0 0 0 0 1 1 C9
23:32:16 10 0FF 0F 0 1 0 1 0 1 1 D1
23:32:16 11 0FF 0F 0 1 0 1 0 1 1 D9
23:32:16 12 0FF 0F 0 1 0 1 0 1 1 E1
23:32:16 13 0FF 0F 0 1 0 1 0 1 1 E9
23:32:17 14 000 00 1 0 0 0 0 0 0 00
23:32:17 15 000 00 1 0 0 0 0 0 0 00
23:32:17 16 000 00 1 0 0 0 0 0 0 00
23:32:17 17 000 00 1 0 0 0 0 0 0 00
23:32:17 IRQ to pin mappings:
23:32:17 0->2 1->1 2->-1 3->3 4->4 5->5 6->6 7->7 8->8 9->9 10->10 11->11 12->12 13->13 14->14 15->15 16->16 17->17 18->18 19->19 20->-1 21->-1 22->-1 23->-1
23:32:17 .................................... done.
23:32:17 PCI: PCI BIOS revision 2.10 entry at 0xfb1b0
23:32:17 PCI: Probing PCI hardware.
23:32:17 PCI->APIC IRQ transform: (B0,I12,P0) -> 18
23:32:17 PCI->APIC IRQ transform: (B0,I14,P0) -> 16
23:32:17 PCI: 00:00 [8086/1237]: Passive release enable (00)
23:32:17 Starting kswapd v 1.5
23:32:17 Serial driver version 4.25 with SHARE_IRQ enabled
23:32:17 ttyS00 at 0x03f8 (irq = 4) is a 16550A
23:32:17 ttyS01 at 0x02f8 (irq = 3) is a 16550A
23:32:17 Real Time Clock Driver v1.09
23:32:17 Ramdisk driver initialized : 16 ramdisks of 4096K size
23:32:17 PIIX3: IDE controller on PCI bus 00 dev 39
23:32:17 PIIX3: not 100% native mode: will probe irqs later
23:32:17 ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio
23:32:17 ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
23:32:17 ncr53c8xx: at PCI bus 0, device 14, function 0
23:32:17 ncr53c8xx: 53c875 detected
23:32:17 ncr53c875-0: rev=0x03, base=0xe2000000, io_port=0x8100, irq=16
23:32:17 ncr53c875-0: ID 7, Fast-20, Parity Checking
23:32:17 ncr53c875-0: on-board RAM at 0xe2001000
23:32:17 ncr53c875-0: restart (scsi reset).
23:32:17 ncr53c875-0: copying script fragments into the on-board RAM ...
23:32:17 scsi0 : ncr53c8xx - revision 2.5f
23:32:17 scsi : 1 host.
23:32:18 Vendor: QUANTUM Model: CTS80S Rev: 4.2
23:32:18 Type: Direct-Access ANSI SCSI revision: 02
23:32:18 Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
23:32:18 ncr53c875-0-<2,0>: using tagged command queueing, up to 4 cmds/lun
23:32:18 Vendor: SEAGATE Model: ST31230N Rev: 0300
23:32:18 Type: Direct-Access ANSI SCSI revision: 02
23:32:18 Detected scsi disk sdb at scsi0, channel 0, id 2, lun 0
23:32:18 ncr53c875-0-<3,0>: using tagged command queueing, up to 4 cmds/lun
23:32:18 Vendor: FUJITSU Model: M2952S-512 Rev: 0142
23:32:18 Type: Direct-Access ANSI SCSI revision: 02
23:32:18 Detected scsi disk sdc at scsi0, channel 0, id 3, lun 0
23:32:18 Vendor: MATSHITA Model: CD-ROM CR-506 Rev: 8S04
23:32:18 Type: CD-ROM ANSI SCSI revision: 02
23:32:18 scsi : detected 3 SCSI disks total.
23:32:18 ncr53c875-0-<1,0>: asynchronous.
23:32:18 SCSI device sda: hdwr sector= 512 bytes. Sectors= 166200 [81 MB] [0.1 GB]
23:32:18 ncr53c875-0-<2,0>: FAST-10 SCSI 10.0 MB/s (100 ns, offset 15)
23:32:18 SCSI device sdb: hdwr sector= 512 bytes. Sectors= 2069860 [1010 MB] [1.0 GB]
23:32:18 ncr53c875-0-<3,0>: FAST-20 SCSI 20.0 MB/s (50 ns, offset 15)
23:32:18 SCSI device sdc: hdwr sector= 512 bytes. Sectors= 4693462 [2291 MB] [2.3 GB]
23:32:18 Partition check:
23:32:18 sda: sda1 sda2
23:32:18 sdb: sdb1 sdb2 sdb3 sdb4 < sdb5 sdb6 >
23:32:18 sdc: sdc1 sdc2
23:32:18 VFS: Mounted root (ext2 filesystem) readonly.
23:32:18 Freeing unused kernel memory: 56k freed
23:32:18 inserting floppy driver for 2.1.102
23:32:18 Floppy drive(s): fd0 is 1.44M
23:32:18 FDC 0 is a post-1991 82077
23:32:18 Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
23:32:18 ncr53c875-0-<6,0>: FAST-5 SCSI 5.0 MB/s (200 ns, offset 15)
23:32:18 Uniform CD-ROM driver Revision: 2.12
23:32:18 Adding Swap: 130748k swap-space (priority -1)
23:32:18 loading device 'eth0'...
23:32:18 ne.c: PCI BIOS reports Realtek 8029 at i/o 0x8000, irq 18.
23:32:18 ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
23:32:18 NE*000 ethercard probe at 0x8000: 00 40 05 5f 55 02
23:32:18 eth0: NE2000 found at 0x8000, using IRQ 18.
23:32:18 loading device 'eth1'...
23:42:10 eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x3, t=782.
23:42:20 eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x3, t=1000.
23:42:22 Socket destroy delayed (r=0 w=512)
23:42:30 eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x3, t=1000.
23:42:32 Socket destroy delayed (r=0 w=512)
23:42:40 eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x3, t=1000.
23:42:42 Socket destroy delayed (r=0 w=512)
23:42:42 Socket destroy delayed (r=0 w=768)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu