my smp computer wont boot with linux v2.0.34pre11b + 5.0.14 aic7xxx patch
v2.0.33 works ok for me ...
with pre11b i got lots of
(scsi0:-1:-1:-1) Bad SCBPTR 16 during SETLO.
(scsi0:-1:-1:-1) Refrenced SCB 255 not valid during SETLO.
SCSISEQ=0x5a SEQADDR=0x8 SSTAT0=0x10 SSTAT1=0x8a
and some timeout messages. this happens while the driver
scans the scsi bus ID2 ... but i have no ID2 scsi device!
here my "normal" scsi boot message (v2.0.33)
aic7xxx: <Adaptec AHA-294X Ultra SCSI host adapter> at PCI 20
aic7xxx: BIOS enabled, IO Port 0x6200, IO Mem 0xe4001000, IRQ 11, Revision B
aic7xxx: Wide Channel, SCSI ID 7, 16/255 SCBs, QFull 16, QMask 0x1f
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.1.1/3.2.1
scsi : 1 host.
scsi0: Scanning channel A for devices.
Vendor: IBM OEM Model: DFHSS4F Rev: 4343
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: SANYO Model: CRD-254S Rev: 1.02
Type: CD-ROM ANSI SCSI revision: 02
Vendor: HP Model: HP35480A Rev: T503
Type: Sequential-Access ANSI SCSI revision: 02
Vendor: IBM Model: DORS-32160 Rev: WA6A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 4, lun 0
Vendor: IBM Model: DCAS-34330W Rev: S61A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdc at scsi0, channel 0, id 8, lun 0
Vendor: IBM Model: DCAS-34330W Rev: S61A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdd at scsi0, channel 0, id 9, lun 0
scsi : detected 4 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8813870 [4303 MB] [4.3 GB]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB] [2.1 GB]
SCSI device sdc: hdwr sector= 512 bytes. Sectors= 8467200 [4134 MB] [4.1 GB]
SCSI device sdd: hdwr sector= 512 bytes. Sectors= 8467200 [4134 MB] [4.1 GB]
cu, oliver
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu