Re: Linux 2.1.x fails on Amd K6/200 (works fine on P200MMX)

Erik Andersen (andersen@inconnect.com)
Wed, 21 Jan 1998 10:07:36 -0700 (MST)


Hmmm. It works fine on _my_ AND K6/200 w/Intel TX chipset.

-Erik

--
Erik B. Andersen   Web:    http://www.inconnect.com/~andersen/ 
                   email:  andersee@debian.org
--This message was written using 73% post-consumer electrons--

On Tue, 20 Jan 1998, Dan Merillat wrote:

> > Really wierd... Right after > PIIX: IDE controller on PCI bus 0 function 57 > PIIX: not 100% native mode: will probe irqs later > ide0: BM-DMA at 0xe800-0xe807, BIOS settings: hda:pio, hdb:pio > > it either fails with > unknown interrupt (and stops) > or > no vm86_info: BAD (and stops) > > This is on a intel HX chipset, 128meg ram, 2.1.79 > > Possibly being bitten by a PGCC bug? Unlikely, since I was running 2.1.x > kernels on this machine with this compiler earlier. > > Any ideas? I have CONFIG_SMP commented out, and did a make dep clean bzImage > afterwords. > > same image runs fine on a P200mmx/64mb/FX chipset. > > I tried with both CONFIG_586 and CONFIG_686, same result. > > --Dan >