I just booted 2.1.76 for the first time (coming from 2.1.72)
and noticed that some device names are reported incorrectly
(the underlining obviously is mine):
scsi : 2 hosts.
scsi0: Target 0, channel A, now synchronous at 20.0MHz, offset 15.
Vendor: SEAGATE Model: ST32155N Rev: 0318
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: IOMEGA Model: ZIP 100 Rev: N*32
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi removable disk sda at scsi1, channel 0, id 5, lun 0
^^^^^^^^
scsi : detected 2 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4197405 [2049 MB] [2.0 GB]
SCSI device sda: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1 GB]
^^^^^^^^^
sda: Write Protect is off
^^^^^^^^
Partition check:
sda: sda1 sda2 sda3 sda4 < sda5 sda6 >
sdb: sdb4
The real sda is sitting on an adaptec 2940AU. sdb is an Iomega ZIP,
connected to its own adapter. Both seem to work fine, only the name
used to refer to sdb is not always correct.
MCE
-- ======================================================================== M. Eyckmans (MCE) Code of the Geeks v3.1 mce@tornado.be GCS d+ s+:- a32 C+++$ UHLUASO+++$ P+ L+++ E--- W++ N+++ !o K w--- !O M-- V-- PS+ PE+ Y+ PGP- t--- !5 !X R- tv- b+ DI++ D-- G++ e+++ h+(*) !r y? ========================================================================