This in the ISA version version of the easyconnect board. It works
like a charm under 2.0.3x, however I get an error message about
invalid rom under 2.1.65. I pulling down the latest firmware and
stlload from ftp.stallion.com, and compiled the utilities under the
correct kernel, but I get the same message.
2.0.3x recognizes the board as follows, 2.1.65 recognizes it with the
same numbers/addresses.
STALLION: EC8/64-AT found, unit=0 io=2a0 mem=cc000 nrpanels=1 nrports=1
The exact error message given is:
./stlload: read of ROM signature failed, errno=1062840300
If i run it by hand several times I get the following:
router-205-64# ./stlload -v -v -v cdk.sys
Using shared memory device /dev/staliomem0
Downloading image /usr/local/stallion/cdk.sys to board 0
Opening shared memory device /dev/staliomem0
Stoping any current slave
Reseting the board
Interrupting board to activate shared memory
Opening slave image file /usr/local/stallion/cdk.sys
Reading ROM signature from board
./stlload: read of ROM signature failed, errno=1062841260
router-205-64# ./stlload -v -v -v cdk.sys
Using shared memory device /dev/staliomem0
Downloading image /usr/local/stallion/cdk.sys to board 0
Opening shared memory device /dev/staliomem0
Stoping any current slave
Reseting the board
Interrupting board to activate shared memory
Opening slave image file /usr/local/stallion/cdk.sys
Reading ROM signature from board
./stlload: read of ROM signature failed, errno=1062840300
dmesg gives me lots of these :
stlload: Exception at [<c019054a>] cr2=1c01e (fixup: c019a2a5)
stlload: Exception at [<c019054a>] cr2=1d01e (fixup: c019a2a5)
stlload: Exception at [<c019054a>] cr2=1e01e (fixup: c019a2a5)
stlload: Exception at [<c019054a>] cr2=1f01e (fixup: c019a2a5)
Allen Smith, lazlor@stardust.com
IP Multicast. Turn it on and tune-in to the future.