mmmhhh... look at this!! (3c509 and Mwave related problems...)

Antonio Dell'elce (linux@repubblica.it)
Tue, 18 Feb 1997 12:44:48 +0100


Hello,

I am a near happy linux 2.1.26 user, and also a programmer.....

I met the followoing my last boot (via loadlin, kos I got an Mwave
card :((, and I have to start SB simulation in dos each time..)

----- PART OF DMESG -----

eth0: Setting Rx mode to 1 addresses.
eth0 UP fl=00001043 pa=47065A64/000000FF brd=FFFFFF64 dst=00000000
eth0 changes netmask 000000FF -> 0000FFFF
eth0 changes brd FFFFFF64 -> FFFF5A64
route forgot to specify route netmask.
lo UP fl=0000004b pa=0100007F/000000FF brd=FFFFFF7F dst=00000000
lo changes brd FFFFFF7F -> FFFFFF7F
eth0 enters promiscuous mode.
eth0: Setting Rx mode to 2 addresses.
eth0: Setting Rx mode to 3 addresses.
eth0: Setting Rx mode to 4 addresses.
Waiting for 3c509 to discard packet, status 2001.
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
eth0: Infinite loop in interrupt, status 2011.
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
Sound: DMA (input) timed out - IRQ/DRQ config error?
UDP: bad checksum. From CE488022:53 to 645A0647:53 ulen 63
TCPv4 bad checksum from 31b7d8cc:0050 to 47065a64:0732,
len=1480/1480/1500
ip_rt_advice: redirect to 479deecd/00 dropped
ip_rt_advice: redirect to 735ca980/00 dropped

----- END OF DMESG -----

well.. what's up with the ethernet card ??

the messages
Waiting for 3c509 to discard packet, status 2001.
eth0: Infinite loop in interrupt, status 2011.
are normal??

also the soundcard (again, an ugly MWave...) works correctly
but the mixer... is the above error related to it??
Which anyway I had only in the latest boot.....

Bye (tnx for your support)

Note: I run AppleTalk.