> Joachim Achtzehnter writes:
>
> > You need to enable UltraSCSI speeds in the board setup (you get
> > there by pressing certain keys during boot). Then the Linux
> > aic7xxx driver automatically enables UltraSCSI support. You can
> > verify this by looking at the file /proc/scsi/aic7xxx/0.
>
> Adding aic7xxx=ultra to lilo's append= options gets me
>
> scsi0: Target 0, channel A, now synchronous at 20.0MHz, offset 15.
> Vendor: SEAGATE Model: ST32155N Rev: 0318
> Type: Direct-Access ANSI SCSI revision: 02
>
> Better than being synch at 10.0MHz. :) This is with an AHA2940U.
> The option isn't documented, I think, but is present in the options
> struct in aic7xxx.c.
>
I didn't notice the startup message. Yes, it really runs at Ultra
when enabled at BIOS setup. Thanx and sorry.
*********************************
Magnus Hiie
Computer Manager
Eesti Ekspress
E-mail: mgn@ekspress.ee
Tel: +372 6408046
GSM: +372 50 57507