I started getting these messages only after I installed and configured
X. These messages seem to be related to something that happened after X
configuration. I am confident of this because when I reinstalled all
the disk sets and recompiled the kernel, everything was OK. The moment I
installed and configured X and rebooted, I got the exact same set of
messages.
I am reproducing the boot time messages below. Lines preceded by
##**## are received only after X configuration.
1. The updating module dependencies porton of the messages is checking
dependencies for modules which I have not compiled into the kernel.
I did not compile tulip or cyclades or any of the others that the kernel
checks for.
2. The card services and card manager messages are new and I did not
receive them before X installation and configuration.
3. I have a standard IDE-ATAPI Sony CD-ROM which was recognized and
mounted without any problems before X. After X, I get unknown CD-ROM
message.
Any ideas on what is going on here?
Thanks
-----------------------------------------------------------------
<several messages deleted>
VFS: Mounted root (ext2 filesystem) readonly
##**## INIT: version 2.62 booting
Adding swap: 26204K swap space
##**## /etc/rc.d/rc.S: Testing filesystem status:
##**## Read only filesystem
##**## Parallelizing fsck version 1.04 (16 May 96)
##**## /dev/hda2: clean, 16329/51584 files, 180093/205632 blocks
##**## Remounting root device with read-write enabled
##**## /dev/hda1 on /dosc type msdos (rw)
##**## /dev/hdb1 on /dosd type msdos (rw)
##**## none on /proc type proc (rw)
##**## Updating modules dependencies for Linux 2.0.0:
##**## *** Unresolved symbols in module /lib/modules/2.0.0/misc/cyclades.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/3C59x.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/de4x5.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/dgrs.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/hp100.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/ne.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/net/tulip.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/53C7,8xxx.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/BusLogic.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/aic7xxx.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/eata_dma.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/eata_pio.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/fdomain.o
##**## *** Unresolved symbols in module /lib/modules/2.0.0/scsi/qlogicisp.o
lp1 at 0x0378, (polling)
CSLIP: ...
SLIP: ...
PPP: ....
Starting PCMCIA services: Linux PCMCIA Card Services 2.8.17
##**## pcibios_present undefined
##**## pcibios_find_device undefined
##**## pcibios_read_config_dword undefined
##**## pcibios_write_config_dword undefined
##**## Loading failed! The module symbols (from Linux 2.0.0) don't match
your linux 2.0.0 card manager.
##**## Jan 9 15:25:19 cardmgr[45]: starting
##**## Jan 9 15:25:19 cardmgr[45]: cardmgr.c 1.79 1996/5/25
##**## INIT: Entering run level: 3
##**## Jan 9 15:25:19 cardmgr[45]: no sockets found!
##**## Jan 9 15:25:19 cardmgr[45]: exiting
##**## Going multiuser ...
Checking for a CD ... ISO9660 Extensions: RRIP_1991A
##**## found on /dev/vdrom.
##**## Mounting unknown ISO9660 CD_ROM under /cdrom
eth0: Setting Rx mode to 1 addresses
Mounting remote filesystems ...
Starting daemons: syslogd klogd portmap inetd lpd mountd nfsd
Starting sendmail daemon
Loading iBCS module ...
Running gpm ...
Welcome to Linux 2.0.0