Re: What's happen on aic7xxx and 2.0.11
Dr. Werner Fink (werner@suse.de)
Fri, 9 Aug 1996 15:30:58 +0200
What does this message means:
> SCSI bus is being reset for host 0 channel 0.
> aic7xxx: (abort_reset) scb state 0x7, Message-In phase, SCSISIGI = 0x54
> aic7xxx: Target 0, channel A, now synchronous at 10.0MHz, offset(0xf).
> aic7xxx: No active SCB for reconnecting target 0, channel A - Issuing
> ABORT. SAVED_TCL(0x0).
> scsi : aborting command due to timeout : pid 71, scsi0, channel 0, id 0,
> lun 0 0x08 03 98 e4 10 00
> aic7xxx: (abort_reset) scb state 0x1, Message-In phase, SCSISIGI = 0x44
> SCSI host 0 abort (pid 71) timed out - resetting
> SCSI bus is being reset for host 0 channel 0.
> aic7xxx: (abort_reset) scb state 0x7, Message-In phase, SCSISIGI = 0x54
> aic7xxx: Target 0, channel A, now synchronous at 10.0MHz, offset(0xf).
>
>
> Thanks
Check the SCSI system ... termination ... cable ... motherboard/BIOS settings
... aha-BIOS settings ... disk/cdrom/tape/device settings ... settings
of your graphic card (no ISA-IRQ for PCI cards) ...
If you use only SCSI-ANSI-2 conform devices you should enable
term power on all devices.
BTW: You've forgotten your hard- and software konfiguration!
Werner