Problems in 2.0.0

S. G. Sanjay (sanjay@mpeg.ece.iisc.ernet.in)
Fri, 14 Jun 1996 13:41:38 +0530 (IST)


Hello all,

I just upgraded my system to 2.0.0 and am facing a few problems :(
As I have just recently joined the mailing list, please forgive me if
these problems were already discussed on the list.

1) ping/telnet to LOCAL HOST ( 144.16.64.10 ) says :

Trying 144.16.64.10...
telnet: Unable to connect to remote host: Network is unreachable

talk also fails saying :

[Error on write to talk daemon : Network is unreachable (101)]

2) We are trying to set up MBONE on our campus. I got mrouted ver-3.8
and tried to run it but I get the following error message :

11:31:29.635 mrouted version 3.8
16:07:06.684 can't enable Multicast routing in kernel: Protocol not available

I have attached the login messages where it says that IGMP is enabled
and so is tunneling.

I was advised to upgrade to 2.0.0 when I posted a query yesterday. The
problem persists even after doing so.

ifconfig eth0 says multicast is running :

mpeg:sanjay > ifconfig eth0

eth0 Link encap:10Mbps Ethernet HWaddr 00:80:C8:14:41:CD
inet addr:144.16.64.10 Bcast:144.16.64.255 Mask:255.255.224.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:137914 errors:0 dropped:0 overruns:0
TX packets:9547 errors:0 dropped:0 overruns:0
Interrupt:5 Base address:0x300

What should I do ? Thanks for all the help in advance ;)

Sanjay

-----------------------------------------------------------------------
mpeg:sanjay > cat dmesg >> /tmp/snd.5022

Console: 16 point font, 400 scans
Console: colour VGA+ 80x25, 1 virtual console (max 63)
Calibrating delay loop.. ok - 33.18 BogoMIPS
Memory: 14836k/16384k available (676k kernel code, 384k reserved, 488k data)
This processor honours the WP bit even when in supervisor mode. Good.
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.12 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: IGMP, ICMP, UDP, TCP, IPIP
VFS: Diskquotas version dquot_5.6.0 initialized
Checking 386/387 coupling... Ok, fpu using exception 16 error reporting.
Checking 'hlt' instruction... Ok.
Linux version 2.0.0 (root@mpeg.ece.iisc.ernet.in) (gcc version 2.7.2) #1 Fri Jun 14 10:22:50 IST 1996
Serial driver version 4.13 with no serial options enabled
tty00 at 0x03f8 (irq = 4) is a 16450
tty01 at 0x02f8 (irq = 3) is a 16450
Ramdisk driver initialized : 16 ramdisks of 4096K size
hda: ST3660A, 520MB w/120kB Cache, LBA, CHS=1057/16/63
hdb: FX400E, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Floppy drive(s): fd0 is 1.44M, fd1 is 1.2M
Started kswapd v 1.4.2.2
FDC 0 is an 8272A
tunnel: version v0.2b2
ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
NE*000 ethercard probe at 0x300: 00 80 c8 14 41 cd
eth0: NE2000 found at 0x300, using IRQ 5.
Partition check:
hda: hda1 hda2
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 24692k swap-space

============================================================================

email : sanjay@mpeg.ece.iisc.ernet.in