LH> Have been using SMC EtherPower PCI Ethernet Card succesfully
LH> for about 4 weeks now using the 1.2.x kernels. However changing
LH> over to the 1.3.x kernels causes the kernel to hang during boot up...
LH> Jun 19 14:52:34 hudsonpc kernel: eth0: tulip_open() irq 9.
LH> Jun 19 14:52:34 hudsonpc kernel: eth0: CSR12 is ffffffc4.
LH> Jun 19 14:52:34 hudsonpc kernel: eth0: Done tulip_open(), CSR0 fff84800, CSR13 ffffef03.
LH> Jun 19 14:52:34 hudsonpc kernel: eth0: transmit timed out, switching to AUI media.
LH> Gets to here and then just stays there... Not Good !
LH> Any Advice??
If you're using 10Base2, try this (from Don Becker's WWW page):
--- tulip.c-0.05.dist Tue Jun 6 04:22:10 1995
+++ tulip.c-0.05 Mon Jun 26 14:50:56 1995
@@ -322,7 +322,7 @@
/* Turn on the xcvr interface. */
outl(0x00000000, ioaddr + CSR13);
- outl(0x00000004, ioaddr + CSR13);
+ outl(0x0000000d, ioaddr + CSR13);
/* Start the chip's Tx and Rx processes. */
outl(0xfffe2002, ioaddr + CSR6);
Worked for me (1.3.3)!
--Up.
-- Jeff Uphoff - systems/network admin. | juphoff@nrao.edu National Radio Astronomy Observatory | jeff.uphoff@linux.org Charlottesville, VA, USA | http://linux.nrao.edu/~juphoff/