Re: [PATCH v5 00/58] mtd: rawnand: retain chip and controller state across removal
From: Miquel Raynal
Date: Thu Nov 19 2026 - 07:49:22 EST
Hi James,
On 15/11/2026 at 23:29:15 -07, James Hilliard <james.hilliard1@xxxxxxxxx> wrote:
> An MTD handle can outlive controller unbind. Its metadata and NAND locks
> must remain valid, including when a writable file closes and calls sync,
> while further hardware access must be rejected after disconnection.
>
> This builds on earlier MTD removal-lifetime work. Commit 19bfa9ebebb5
> ("mtd: use refcount to prevent corruption") added MTD reference counting
> [0], but retaining an MTD reference does not by itself retain the
> driver-owned allocation containing the master. The read/unbind discussion
> also covered raw NAND [1] and draining active operations [2]. Tze Yee Ng's
> SPI-NOR series addresses the corresponding SPI-NOR paths [3].
>
> Following Greg's review [7], separate class-device data from the MTD
> backing allocation. Delete the device's interfaces and drain NVMEM and
> class PM callbacks before releasing backing data. Bare device references
> retain an independently allocated device, whose type, PM dispatch and
> final release are built in even when MTD is modular. NVMEM similarly
> disconnects and drains provider and layout callbacks before unregister
> returns; retained consumers keep core-owned metadata and receive -ENODEV
> on subsequent access.
>
> Introduce opt-in backing-object ownership for MTD masters. Registered
> nodes and acquired MTD handles retain the chip, while nested partitions
> also retain their parent metadata. Unregister first so removal notifiers
> can finish I/O, then disconnect raw NAND and drain admitted operations.
> Hardware resources can be released without waiting for open files to close.
>
> Virtual concatenations serialize publication and removal across physical
> controllers. Disconnect and drain a published concatenation before any
> component can disappear, then release its component references. An old
> handle keeps the disconnected virtual device, independently of a later
> replacement.
>
> Run NAND and controller-specific cleanup during disconnection, while
> the controller driver is still bound. Snapshot the OOB layout in core-owned
> data before publication so metadata queries remain valid without driver
> callbacks. The NAND core frees retained chip and controller allocations;
> the final MTD put never calls back into the controller module. Ordinary
> MTD and NVMEM handles retain the NAND core that implements their
> operations, rather than the hardware driver.
>
> Share allocation ownership across the raw-NAND drivers, including
> partially published probes. Shared controllers remain allocated until
> their last retained chip is released. R852 allocates a new chip for each
> card, and NDFC allocates controller state per binding.
>
> Based on NAND next at 30daaf3e7897, with Tze Yee Ng's module-reference
> ordering fix [4], Karl Mehltretter's OTP cleanup fix [6], and the separately
> posted registration, operation-locking and controller probe/teardown fixes
> identified by the prerequisite metadata. TLA+ models and their assumptions
> and coverage limits are available in [5].
While lifetime issues are a real concern in the kernel, please note that
in general, removing or unbinding the flash controller driver is not a
practical operation. While highly unlikely, this is possible though. But
I am not going to sacrifice all the devm_ calls in favor of reinstating
manual error handling just for that. If there is a way, it must be
different.
Also, this kind of contribution can only be done if you *understand*
what you are doing. Getting the big picture here is not optional.
Maybe the problem is MTD refcounting? Maybe the problem is the devm_
orderging? I don't know, I haven't looked in depth at all the
patches. But the current approach is clearly not acceptable.
Thanks,
MIquèl