On 07/07/2025 04:51, Yu Zhang(Yuriy) wrote:I appreciate your comments and apologize for the repeated submissions. Due to a possible issue with my Thunderbird client, I did not receive earlier replies and was unaware of additional feedback.
Add a node for the PMU module of the WCN6855 present on the qcs615 ride
board. Assign its LDO power outputs to the existing WiFi/BT module.
Signed-off-by: Yu Zhang(Yuriy) <yu.zhang@xxxxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs615-ride.dts | 135 +++++++++++++++++++++++++++++++
1 file changed, 135 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
index 011f8ae077c256f079ce1b07720374a9bf721488..2df8e7e3c1d3b6d6353a6753b8387c7411edd927 100644
--- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
@@ -18,6 +18,7 @@ aliases {
mmc0 = &sdhc_1;
mmc1 = &sdhc_2;
serial0 = &uart0;
+ serial1 = &uart7;
};
chosen {
@@ -47,6 +48,85 @@ regulator-usb2-vbus {
enable-active-high;
regulator-always-on;
};
+
+ vreg_conn_1p8: vreg_conn_1p8 {
Are you going to keep sending the same? Third or fourth time, even
though there were comments? Please take comments seriously and implement
them or at least RESPOND.
NAK
Best regards,
Krzysztof