Re: [PATCH 3/4] arm64: dts: qcom: Add HAMOA-IOT-SOM platform

[Yijie Yang]

On 2025-07-23 19:26, Dmitry Baryshkov wrote:
> On Wed, Jul 23, 2025 at 02:44:14PM +0800, Yijie Yang wrote:
> > On 2025-07-23 14:28, Krzysztof Kozlowski wrote:
> > > On 16/07/2025 11:08, Yijie Yang wrote:
> > > > The HAMOA-IOT-SOM is a compact computing module that integrates a System
> > > > on Chip (SoC) — specifically the x1e80100 — along with essential
> > > > components optimized for IoT applications. It is designed to be mounted on
> > > > carrier boards, enabling the development of complete embedded systems.
> > > >
> > > > This change enables and overlays the following components:
> > > > - Regulators on the SOM
> > > > - Reserved memory regions
> > > > - PCIe6a and its PHY
> > > > - PCIe4 and its PHY
> > > > - USB0 through USB6 and their PHYs
> > > > - ADSP, CDSP
> > > > - WLAN, Bluetooth (M.2 interface)
> > > >
> > > > Written with contributions from Yingying Tang (added PCIe4 and its PHY to
> > > > enable WLAN).
> > > >
> > > > Signed-off-by: Yijie Yang <yijie.yang@xxxxxxxxxxxxxxxx>
> > > > ---
> > >
> > > As pointed out by "arm64: dts: qcom: hamoa-iot-evk: Enable display
> > > support" this is incomplete. Adding new SoM or board is one commit. Not
> > > two. Don't split board DTS, which is already prepared/ready, into
> > > multiple fake commits. This is not a release early approach. This is
> > > opposite!
> >
> > The inclusion of display support was not intended in the initial patch, and
> > it was not ready at the time this series was submitted. Since the display
> > patch set was not submitted by me, its timing could not be controlled. If
> > preferred, the display-related changes can be merged into this patch in the
> > next revision to maintain consistency.
>
> This is neither merged nor accepted. Please squash display (and any
> other possible forthcoming changes) into this patchset before reposting

Sure, I will.

>

--
Best Regards,
Yijie