[PATCH V4 1/2] dt-bindings: leds: pwm: add enable-gpios property

[LI Qingwu]

some pwm led driver chips like tps92380 require a separate enable signal
in addition to pwm control. this property allows device trees to specify
such gpio, which will be controlled automatically by the driver based
on the led brightness state.

Signed-off-by: LI Qingwu <Qing-wu.Li@xxxxxxxxxxxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/leds/leds-pwm.yaml | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/leds/leds-pwm.yaml b/Documentation/devicetree/bindings/leds/leds-pwm.yaml
index 61b97e8bc36d0..6c4fcefbe25f9 100644
--- a/Documentation/devicetree/bindings/leds/leds-pwm.yaml
+++ b/Documentation/devicetree/bindings/leds/leds-pwm.yaml
@@ -40,6 +40,13 @@ patternProperties:
           initialization. If the option is not set then max brightness is used.
         $ref: /schemas/types.yaml#/definitions/uint32
 
+      enable-gpios:
+        description:
+          GPIO for LED hardware enable control. Set active when brightness is
+          non-zero and inactive when brightness is zero.
+          The GPIO default state follows the "default-state" property.
+        maxItems: 1
+
     required:
       - pwms
       - max-brightness
-- 
2.43.0