[PATCH v7 5/5] arm64: dts: qcom: qcs8300-ride: enable pcie1 interface

[Ziyue Zhang]

Add configurations in devicetree for PCIe1, board related gpios,
PMIC regulators, etc for qcs8300-ride platform.

Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
Signed-off-by: Ziyue Zhang <quic_ziyuzhan@xxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 40 +++++++++++++++++++++++
 1 file changed, 40 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
index e8e382db2b99..bec2905c5d8f 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
@@ -325,6 +325,23 @@ &pcie0_phy {
 	status = "okay";
 };
 
+&pcie1 {
+	perst-gpios = <&tlmm 23 GPIO_ACTIVE_LOW>;
+	wake-gpios = <&tlmm 21 GPIO_ACTIVE_HIGH>;
+
+	pinctrl-0 = <&pcie1_default_state>;
+	pinctrl-names = "default";
+
+	status = "okay";
+};
+
+&pcie1_phy {
+	vdda-phy-supply = <&vreg_l6a>;
+	vdda-pll-supply = <&vreg_l5a>;
+
+	status = "okay";
+};
+
 &qupv3_id_0 {
 	status = "okay";
 };
@@ -388,6 +405,29 @@ perst-pins {
 			bias-pull-down;
 		};
 	};
+
+   pcie1_default_state: pcie1-default-state {
+		wake-pins {
+			pins = "gpio21";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+
+		clkreq-pins {
+			pins = "gpio22";
+			function = "pcie1_clkreq";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+
+		perst-pins {
+			pins = "gpio23";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-down;
+		};
+	};
 };
 
 &uart7 {
-- 
2.34.1