Re: [PATCH v2] net: ethernet: mtk_eth_soc: support named IRQs

[Frank Wunderlich (linux)]

Am 2025-06-15 12:13, schrieb Lorenzo Bianconi:
> > Am 2025-06-15 10:57, schrieb Lorenzo Bianconi:
> > > > From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
> > > >
> > > Hi Frank,
> > >
> > > I guess my comments on v1 apply even in v2. Can you please take a look?
>
> sure

:)

> > Am 2025-06-15 10:57, schrieb Lorenzo Bianconi:
> > > > From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>

> I am fine to have it in a separate patch but I would prefer to have 
> this patch
> in the same series, I think it is more clear.

I added changes for your and daniels comments to my repo (top 2 
commits):

https://github.com/frank-w/BPI-Router-Linux/commits/6.16-mt7988upstream/

i would squash daniels suggestions in this patch here (MAX without __ 
and fixed
value of 3 to use for the loop - i guess this was intended for this 
purpose) and
then the change for index in second patch.

> > > Same here, if you are not listing them in the device tree, you can
> > > remove them
> > > in the driver too (and adjust the code to keep the backward
> > > compatibility).

i plan to use named IRQs on mt7988 without the reserved ones (only rx+tx 
+ RSS IRQs),
and loading not index based.

> > afaik i have no SHARED_INT board (only mt7621, mt7628) so changing the
> > index-logic will require testing on such boards too.
>
> I think the change will not heavily impact SHARED_INT devices.

I hope so ;)

> Regards,
> Lorenzo

regards Frank