[PATCH] firewire: ohci: correct code comments about bus_reset tasklet

[Takashi Sakamoto]

The tasklet for bus reset event has been replaced with work item, while
some code comments still address to the tasklet.

This commit corrects them.

Fixes: 2d7a36e23300 ("firewire: ohci: Move code from the bus reset tasklet into a workqueue")
Signed-off-by: Takashi Sakamoto <o-takashi@xxxxxxxxxxxxx>
---
 drivers/firewire/ohci.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c
index edaedd156a6d..27e3e998e6fc 100644
--- a/drivers/firewire/ohci.c
+++ b/drivers/firewire/ohci.c
@@ -2528,7 +2528,7 @@ static int ohci_enable(struct fw_card *card,
 	 * They shouldn't do that in this initial case where the link
 	 * isn't enabled.  This means we have to use the same
 	 * workaround here, setting the bus header to 0 and then write
-	 * the right values in the bus reset tasklet.
+	 * the right values in the bus reset work item.
 	 */
 
 	if (config_rom) {
@@ -2617,7 +2617,7 @@ static int ohci_set_config_rom(struct fw_card *card,
 	 * during the atomic update, even on little endian
 	 * architectures.  The workaround we use is to put a 0 in the
 	 * header quadlet; 0 is endian agnostic and means that the
-	 * config rom isn't ready yet.  In the bus reset tasklet we
+	 * config rom isn't ready yet.  In the bus reset work item we
 	 * then set up the real values for the two registers.
 	 *
 	 * We use ohci->lock to avoid racing with the code that sets
@@ -2659,7 +2659,7 @@ static int ohci_set_config_rom(struct fw_card *card,
 	/*
 	 * Now initiate a bus reset to have the changes take
 	 * effect. We clean up the old config rom memory and DMA
-	 * mappings in the bus reset tasklet, since the OHCI
+	 * mappings in the bus reset work item, since the OHCI
 	 * controller could need to access it before the bus reset
 	 * takes effect.
 	 */
-- 
2.48.1