Re: [PATCH v4 04/11] iio: accel: adxl313: add function to enable measurement

[Andy Shevchenko]

On Sun, Jun 1, 2025 at 8:21 PM Lothar Rubusch <l.rubusch@xxxxxxxxx> wrote:
>
> Rework controlling measurement and standby of the sensor. Therefore,
> replace writing the register directly by encapsulating this and dealing
> with the return value in a separte function to enable and disable

separate

(Please, go with a spell check before sending a new version)

> measurement. This will help to avoid redundant code in all locations
> where the sensor configuration needs to be adjusted, thus measurement will
> be set to standby, in follow up patches.
>
> Further, reduce the control mask to only the measurement bit. The sleep bit
> actually controls a different behavior (not just putting the sensor to
> standby for configuration, but turning it into sleep mode) and it is not
> used so far. In consequence, there is no need to cover sleep bit and

cover the sleep

> measurement with the same mask.

-- 
With Best Regards,
Andy Shevchenko