Re: [PATCH] dt-bindings: soc: Add new board description for MicroBlaze V

[Michal Simek]

On 11/7/23 22:18, Conor Dooley wrote:
> On Tue, Nov 07, 2023 at 12:09:58PM +0100, Michal Simek wrote:
> > On 11/6/23 18:07, Conor Dooley wrote:
> > > On Mon, Nov 06, 2023 at 12:53:40PM +0100, Michal Simek wrote:
> > > > MicroBlaze V is new AMD/Xilinx soft-core 32bit RISC-V processor IP.
> > > > It is hardware compatible with classic MicroBlaze processor. Processor can
> > > > be used with standard AMD/Xilinx IPs including interrupt controller and
> > > > timer.
> > > >
> > > > Signed-off-by: Michal Simek <michal.simek@xxxxxxx>
> > > > ---
> > > >
> > > >    .../devicetree/bindings/soc/amd/amd.yaml      | 26 +++++++++++++++++++
> > >
> > > Bindings for SoCs (and by extension boards with them) usually go to in
> > > $arch/$vendor.yaml not into soc/$vendor/$vendor.yaml. Why is this any
> > > different?
> >
> > I actually found it based on tracking renesas.yaml which describes one of
> > risc-v board. No problem to move it under bindings/riscv/
>
> That one is kinda a special case, as it contains arm/arm64/riscv.

If they are kinda a special case then what are we?
All AMD/Xilinx platforms(ZynqMP/Versal/Versal NET) can have 
arm/arm64/riscv/microblaze cpus(riscv/microblaze as soft cores) in the same 
board (IIRC I have also seen xtensa soft core on our chips too).

Thanks,
Michal