[PATCH v1 1/1] serial: core: Simplify uart_get_rs485_mode()

From: Andy Shevchenko
Date: Wed Jul 26 2023 - 08:23:46 EST


Simplify uart_get_rs485_mode() by using temporary variable for
the GPIO descriptor. With that, use proper type for the flags
of the GPIO descriptor.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/serial_core.c | 30 ++++++++++++------------------
1 file changed, 12 insertions(+), 18 deletions(-)

diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
index 831d033611e6..1eab3abd955a 100644
--- a/drivers/tty/serial/serial_core.c
+++ b/drivers/tty/serial/serial_core.c
@@ -3565,9 +3565,10 @@ int uart_get_rs485_mode(struct uart_port *port)
{
struct serial_rs485 *rs485conf = &port->rs485;
struct device *dev = port->dev;
+ enum gpiod_flags dflags;
+ struct gpio_desc *desc;
u32 rs485_delay[2];
int ret;
- int rx_during_tx_gpio_flag;

ret = device_property_read_u32_array(dev, "rs485-rts-delay",
rs485_delay, 2);
@@ -3606,26 +3607,19 @@ int uart_get_rs485_mode(struct uart_port *port)
* bus participants enable it, no communication is possible at all.
* Works fine for short cables and users may enable for longer cables.
*/
- port->rs485_term_gpio = devm_gpiod_get_optional(dev, "rs485-term",
- GPIOD_OUT_LOW);
- if (IS_ERR(port->rs485_term_gpio)) {
- ret = PTR_ERR(port->rs485_term_gpio);
- port->rs485_term_gpio = NULL;
- return dev_err_probe(dev, ret, "Cannot get rs485-term-gpios\n");
- }
+ desc = devm_gpiod_get_optional(dev, "rs485-term", GPIOD_OUT_LOW);
+ if (IS_ERR(desc))
+ return dev_err_probe(dev, PTR_ERR(desc), "Cannot get rs485-term-gpios\n");
+ port->rs485_term_gpio = desc;
if (port->rs485_term_gpio)
port->rs485_supported.flags |= SER_RS485_TERMINATE_BUS;

- rx_during_tx_gpio_flag = (rs485conf->flags & SER_RS485_RX_DURING_TX) ?
- GPIOD_OUT_HIGH : GPIOD_OUT_LOW;
- port->rs485_rx_during_tx_gpio = devm_gpiod_get_optional(dev,
- "rs485-rx-during-tx",
- rx_during_tx_gpio_flag);
- if (IS_ERR(port->rs485_rx_during_tx_gpio)) {
- ret = PTR_ERR(port->rs485_rx_during_tx_gpio);
- port->rs485_rx_during_tx_gpio = NULL;
- return dev_err_probe(dev, ret, "Cannot get rs485-rx-during-tx-gpios\n");
- }
+ dflags = (rs485conf->flags & SER_RS485_RX_DURING_TX) ?
+ GPIOD_OUT_HIGH : GPIOD_OUT_LOW;
+ desc = devm_gpiod_get_optional(dev, "rs485-rx-during-tx", dflags);
+ if (IS_ERR(desc))
+ return dev_err_probe(dev, PTR_ERR(desc), "Cannot get rs485-rx-during-tx-gpios\n");
+ port->rs485_rx_during_tx_gpio = desc;

return 0;
}
--
2.40.0.1.gaa8946217a0b