[PATCH net-next v1 00/14] Add TJA1120 support

[Radu Pirea (NXP OSS)]

Hello everyone,

This patch series got bigger than I expected. It cleans up the
next-c45-tja11xx driver and adds support for the TJA1120(1000BaseT1
automotive phy).

Master/slave custom implementation was replaced with the generic
implementation (genphy_c45_config_aneg/genphy_c45_read_status).

The TJA1120 and TJA1103 are a bit different when it comes to the PTP
interface. The timestamp read procedure was changed, some addresses were
changed and some bits were moved from one register to another. Adding
TJA1120 support was tricky, and I tried not to duplicate the code. If
something looks too hacky to you, I am open to suggestions.

Cheers,
Radu P

Radu Pirea (NXP OSS) (14):
  net: phy: nxp-c45-tja11xx: fix the PTP interrupt enablig/disabling
  net: phy: nxp-c45-tja11xx: use phylib master/slave implementation
  net: phy: nxp-c45-tja11xx: remove RX BIST frame counters
  net: phy: nxp-c45-tja11xx: add *_reg_field functions
  net: phy: nxp-c45-tja11xx: prepare the ground for TJA1120
  net: phy: add 1000baseT1 to phy_basic_t1_features
  net: phy: nxp-c45-tja11xx: add TJA1120 support
  net: phy: nxp-c45-tja11xx: enable LTC sampling on both ext_ts edges
  net: phy: nxp-c45-tja11xx: read egress ts on TJA1120
  net: phy: nxp-c45-tja11xx: handle FUSA irq
  net: phy: nxp-c45-tja11xx: run cable test with the PHY in test mode
  net: phy: nxp-c45-tja11xx: read ext trig ts TJA1120
  net: phy: nxp-c45-tja11xx: reset PCS if the link goes down
  net: phy: nxp-c45-tja11xx: timestamp reading workaround for TJA1120

 drivers/net/phy/Kconfig           |    2 +-
 drivers/net/phy/nxp-c45-tja11xx.c | 1113 ++++++++++++++++++++++-------
 drivers/net/phy/phy_device.c      |    3 +-
 include/linux/phy.h               |    2 +-
 4 files changed, 846 insertions(+), 274 deletions(-)

-- 
2.34.1