Re: [PATCH] regulator: wm8994: Use PROBE_FORCE_SYNCHRONOUS

[Charles Keepax]

On Thu, Mar 23, 2023 at 09:53:18AM -0700, Doug Anderson wrote:
> On Thu, Mar 23, 2023 at 4:40 AM Charles Keepax
> If my analysis is correct, there's still potential to run into similar
> problems even with PROBE_FORCE_SYNCHRONOUS. I don't think that
> mfd_add_devices() is _guaranteed_ to finish probing all the
> sub-devices by the time it returns. Specifically, imagine that
> wm8994_ldo_probe() tries to get a GPIO that that system hasn't made
> available yet. Potentially the system could return -EPROBE_DEFER there
> and that would put the LDO on the deferred probe list. Doing so won't
> cause mfd_add_devices() to fail. Now we'll end up with a dummy
> regulator again. Admittedly most cases GPIO providers probe really
> early and so this argument is a bit of a stretch, but I guess the
> point is that there's no official guarantee that mfd_add_devices()
> will finish probing all sub-devices so it's not ideal to rely on.
> Also, other drivers with a similar pattern might have other reasons to
> -EPROBE_DEFER.
> 
> These types of issues are the same ones I faced with DP AUX bus and
> the solutions were never super amazing...
> 
> One solution we ended up with for the DP AUX bus was to add a
> "done_probing" callback argument to devm_of_dp_aux_populate_bus().
> This allowed the parent to be called back when all the children were
> done probing. This implementation is easier for DP AUX bus than it
> would be in the generic MFD case, but conceivably it would be possible
> there too?
> 
> Another possible solution is to somehow break the driver up into more
> sub-drivers. Essentially, you have a top-level "wm8994" that's not
> much more than a container. Then you create a new-sub-device and
> relegate anything that needs the regulators to the new sub-device. The
> new sub-device can just -EPROBE_DEFER until it detects that the
> regulators have finished probing. I ended up doing stuff like this for
> "ti-sn65dsi86.c" using the Linux aux bus (not to be confused with the
> DP Aux bus) and it was a bit odd but worked OK.

Yes I believe you are correct, there is still an issue here,
indeed a quick test suggests I can still cause this by forcing a
probe defer in the regulator driver.

I think really the best place to look at this would be at the
regulator level. It is fine if mfd_add_devices passes, the problem
really is that the regulator core doesn't realise the regulator is
going to be arriving, and thus returns a dummy regulator, rather
than returning EPROBE_DEFER. If it did the MFD driver would probe
defer at the point of requesting the regulator, which would all
make sense.

I will see if I can find some time to think about that further
but very unlikely to happen this week.

Thanks,
Charles