[PATCH net-next 3/9] net: dpaa: avoid one skb_reset_mac_header() in dpaa_enable_tx_csum()

[Vladimir Oltean]

It appears that dpaa_enable_tx_csum() only calls skb_reset_mac_header()
to get to the VLAN header using skb_mac_header().

We can use skb_vlan_eth_hdr() to get to the VLAN header based on
skb->data directly. This avoids spending a few cycles to set
skb->mac_header.

Signed-off-by: Vladimir Oltean <vladimir.oltean@xxxxxxx>
---
 drivers/net/ethernet/freescale/dpaa/dpaa_eth.c | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/net/ethernet/freescale/dpaa/dpaa_eth.c b/drivers/net/ethernet/freescale/dpaa/dpaa_eth.c
index 9318a2554056..1fa676308c5e 100644
--- a/drivers/net/ethernet/freescale/dpaa/dpaa_eth.c
+++ b/drivers/net/ethernet/freescale/dpaa/dpaa_eth.c
@@ -1482,13 +1482,8 @@ static int dpaa_enable_tx_csum(struct dpaa_priv *priv,
 	parse_result = (struct fman_prs_result *)parse_results;
 
 	/* If we're dealing with VLAN, get the real Ethernet type */
-	if (ethertype == ETH_P_8021Q) {
-		/* We can't always assume the MAC header is set correctly
-		 * by the stack, so reset to beginning of skb->data
-		 */
-		skb_reset_mac_header(skb);
-		ethertype = ntohs(vlan_eth_hdr(skb)->h_vlan_encapsulated_proto);
-	}
+	if (ethertype == ETH_P_8021Q)
+		ethertype = ntohs(skb_vlan_eth_hdr(skb)->h_vlan_encapsulated_proto);
 
 	/* Fill in the relevant L3 parse result fields
 	 * and read the L4 protocol type
-- 
2.34.1