Re: [PATCH v5 0/9] arm64: dts: qcom: sa8775p-ride: enable relevant QUPv3 IPs

[Bartosz Golaszewski]

On Thu, Mar 9, 2023 at 11:37 AM Bartosz Golaszewski <brgl@xxxxxxxx> wrote:
>
> From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
>
> This enables the QUPv3 interfaces that are exposed on the sa8775p-ride
> board: I2C, SPI and the Bluetooth and GNSS UART ports.
>
> v4 -> v5:
> - remove board-specific interrupt from UART17 in SoC dtsi
> - rearrange node properties to have various *-cells properties come right
>   before status
> - collect more tags
>
> v3 -> v4:
> - use interconnect constants instead of magic numbers where applicable
> - pad addresses in reg to 8 digits
> - group pins under state nodes for UART
>
> v2 -> v3:
> - fix the interrupt number for uart12
> - replace underscores with hyphens in DT node names (although make dtbs_check
>   does not raise warnings about this)
> - rearrange the commits so that they're more fine-grained with separate
>   patches for adding nodes to dtsi and enabling them for the board
>
> v1 -> v2:
> - uart17 is the Bluetooth port, not GNSS
> - add uart12 for GNSS too in that case
>
> Bartosz Golaszewski (9):
>   arm64: dts: qcom: sa8775p: add the QUPv3 #2 node
>   arm64: dts: qcom: sa8775p-ride: enable QUPv3 #2
>   arm64: dts: qcom: sa8775p: add the i2c18 node
>   arm64: dts: qcom: sa8775p-ride: enable i2c18
>   arm64: dts: qcom: sa8775p: add the spi16 node
>   arm64: dts: qcom: sa8775p-ride: enable the SPI node
>   arm64: dts: qcom: sa8775p: add high-speed UART nodes
>   arm64: dts: qcom: sa8775p-ride: enable the GNSS UART port
>   arm64: dts: qcom: sa8775p-ride: enable the BT UART port
>
>  arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 99 +++++++++++++++++++++++
>  arch/arm64/boot/dts/qcom/sa8775p.dtsi     | 86 ++++++++++++++++++++
>  2 files changed, 185 insertions(+)
>
> --
> 2.37.2
>

Bjorn,

I noticed you're picking up the reviewed patches. :) This series seems
ready to go into your tree as well.

Thanks in advance,
Bartosz