Re: [PATCH net-next v6 5/9] net: phy: add genphy_c45_ethtool_get/set_eee() support

[Oleksij Rempel]

On Wed, Feb 08, 2023 at 11:32:07AM +0100, Oleksij Rempel wrote:
> Add replacement for phy_ethtool_get/set_eee() functions.
> 
> Current phy_ethtool_get/set_eee() implementation is great and it is
> possible to make it even better:
> - this functionality is for devices implementing parts of IEEE 802.3
>   specification beyond Clause 22. The better place for this code is
>   phy-c45.c
> - currently it is able to do read/write operations on PHYs with
>   different abilities to not existing registers. It is better to
>   use stored supported_eee abilities to avoid false read/write
>   operations.
> - the eee_active detection will provide wrong results on not supported
>   link modes. It is better to validate speed/duplex properties against
>   supported EEE link modes.
> - it is able to support only limited amount of link modes. We have more
>   EEE link modes...
> 
> By refactoring this code I address most of this point except of the last
> one. Adding additional EEE link modes will need more work.
> 
> Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
  
> +/**
> + * genphy_c45_eee_is_active - get EEE supported and status
> + * @phydev: target phy_device struct
> + * @data: ethtool_eee data

I forgot to update this comment.

> + *
> + * Description: it reports the possible state of EEE functionality.
> + */
> +int genphy_c45_eee_is_active(struct phy_device *phydev, unsigned long *adv,
> +			     unsigned long *lp, bool *is_enabled)
> +{
> +	__ETHTOOL_DECLARE_LINK_MODE_MASK(tmp_adv) = {};
> +	__ETHTOOL_DECLARE_LINK_MODE_MASK(tmp_lp) = {};
> +	__ETHTOOL_DECLARE_LINK_MODE_MASK(common);
> +	bool eee_enabled, eee_active;
> +	int ret;
> +
> +	ret = genphy_c45_read_eee_adv(phydev, tmp_adv);
> +	if (ret)
> +		return ret;
> +
> +	ret = genphy_c45_read_eee_lpa(phydev, tmp_lp);
> +	if (ret)
> +		return ret;
> +
> +	eee_enabled = !linkmode_empty(tmp_adv);
> +	linkmode_and(common, tmp_adv, tmp_lp);
> +	if (eee_enabled && !linkmode_empty(common))i

and linkmode_empty() can be replaced with linkmode_intersects()

I'll wait if more comments will come and make a new version tomorrow.

Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |