Re: [PATCH v9 14/27] gunyah: vm_mgr: Add ioctls to support basic non-proxy VM boot

[Elliot Berman]

On 1/30/2023 12:53 AM, Srivatsa Vaddagiri wrote:
> * Elliot Berman <quic_eberman@xxxxxxxxxxx> [2023-01-20 14:46:13]:
>
> > +static int gh_vm_start(struct gunyah_vm *ghvm)
> > +{
> > +	struct gunyah_vm_memory_mapping *mapping;
> > +	u64 dtb_offset;
> > +	u32 mem_handle;
> > +	int ret;
> > +
> > +	down_write(&ghvm->status_lock);
> > +	if (ghvm->vm_status != GH_RM_VM_STATUS_NO_STATE) {
> > +		up_write(&ghvm->status_lock);
> > +		return 0;
>
> return -EINVAL in this case.
>
> Additionally check if its already GH_RM_VM_STATUS_READY and return 0 in that
> case.
>
> [snip]

Caller can use gh_vm_ensure_started for this behavior. I'll move this to 
be used in the GH_VM_RUN ioctl as well.

> > +	mem_handle = mapping->parcel.mem_handle;
> > +	dtb_offset = ghvm->dtb_config.gpa - mapping->guest_phys_addr;
> > +
> > +	ret = gh_rm_vm_configure(ghvm->rm, ghvm->vmid, ghvm->auth, mem_handle,
> > +				0, 0, dtb_offset, ghvm->dtb_config.size);
>
> Default value of auth is 0 (GH_RM_VM_AUTH_NONE). Is that what you wanted here?
> Perhaps initialize default value of auth to be GH_RM_VM_AUTH_QCOM_PIL_ELF?

Yes, default VM is GH_RM_VM_AUTH_NONE.