[PATCH v2 0/8] scsi: libsas: sas address comparation refactor

[Jason Yan]

Sas address conversion and comparation is widely used in libsas and
drivers. However they are all opencoded and to avoid the line spill over
80 columns, are mostly split into multi-lines.

To make the code easier to read, introduce some helpers with clearer
semantics and replace the opencoded segments with them.

v1->v2:
  First factor out sas_find_attached_phy() and replace LLDDs's code
  	with it.
  Remove three too simple helpers.
  Rename the helpers with 'sas_' prefix.

Jason Yan (8):
  scsi: libsas: introduce sas_find_attached_phy() helper
  scsi: pm8001: use sas_find_attached_phy() instead of open coded
  scsi: mvsas: use sas_find_attached_phy() instead of open coded
  scsi: hisi_sas: use sas_find_attathed_phy() instead of open coded
  scsi: libsas: introduce sas address comparation helpers
  scsi: libsas: use sas_phy_match_dev_addr() instead of open coded
  scsi: libsas: use sas_phy_addr_same() instead of open coded
  scsi: libsas: use sas_phy_match_port_addr() instead of open coded

 drivers/scsi/hisi_sas/hisi_sas_main.c | 12 ++------
 drivers/scsi/libsas/sas_expander.c    | 40 ++++++++++++++++-----------
 drivers/scsi/libsas/sas_internal.h    | 17 ++++++++++++
 drivers/scsi/mvsas/mv_sas.c           | 15 +++-------
 drivers/scsi/pm8001/pm8001_sas.c      | 16 ++++-------
 include/scsi/libsas.h                 |  2 ++
 6 files changed, 54 insertions(+), 48 deletions(-)

-- 
2.31.1