Re: [PATCH v6 05/13] dt-bindings: backlight: Add MediaTek MT6370 backlight

[ChiaEn Wu]

On Fri, Jul 22, 2022 at 6:24 PM ChiaEn Wu <peterwu.pub@xxxxxxxxx> wrote:
>
> Signed-off-by: ChiYuan Huang <cy_huang@xxxxxxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> ---

[snip]

> +  compatible:
> +    const: mediatek,mt6370-backlight
> +
> +  default-brightness:
> +    minimum: 0
> +    maximum: 2048
> +
> +  max-brightness:
> +    minimum: 0
> +    maximum: 2048
> +

Hi Rob, Krzysztof,

First, I'm so sorry for our SoB writing wrong, I'll fix it in the next patch.
Because of this mail thread
(https://lore.kernel.org/all/20220728113109.7gf3b36mqjxlhcq3@xxxxxxxxx/),
I would like to discuss with you that I may change the following in
this DT document, I am not sure whether you agree or not.

1. Add some descriptions about MT6372, which supports 16384 steps (14
bits) and is different from MT6370/MT6371 (2048 steps, 11 bits)
2. Modify the format of 'compatible' as follows to distinguish between
MT6370/MT6371 or MT6372
------------------------------------------
properties:
  compatible:
    enum:
      - mediatek,mt6370-backlight
      - mediatek,mt6372-backlight
------------------------------------------

3. Remove the 'maximum' value of 'default-brightness' and
'max-brightness', and add "if-else" to determine the "maximum" value
as follows
------------------------------------------
  default-brightness:
    minimum: 0

  max-brightness:
    minimum: 0

...

if:
  properties:
    compatible:
      contains:
        const: mediatek,mt6372-backlight

then:
  properties:
    default-brightness:
      maximum: 16384

    max-brightness:
      maximum: 16384

else:
  properties:
    default-brightness:
      maximum: 2048

    max-brightness:
      maximum: 2048
------------------------------------------

4. Add a new boolean property to allow the user to determine whether
to enable the exponential mode of backlight brightness or not. Like
this,
------------------------------------------
  mediatek,bled-exponential-mode-enable:
    description: |
      Enable the exponential mode of backlight brightness. If this property
      is not enabled, the default is to use linear mode.
    type: boolean
------------------------------------------

I hope these changes I have added will meet your expectations.
And I'm not sure if I should remove 'Reviewed-By' first until it
passes your review.
Thanks.

-- 
Best Regards,
ChiaEn Wu