Re: [PATCH v11 0/3] Add basic node support for MediaTek MT8186 SoC

[Matthias Brugger]

On 22/06/2022 17:40, Matthias Brugger wrote:
> On 20/05/2022 14:22, Allen-KH Cheng wrote:
> > MT8186 is a SoC based on 64bit ARMv8 architecture.
> > It contains 6 CA55 and 2 CA76 cores.
> > MT8186 share many HW IP with MT65xx series.
> >
> > This patchset was tested on MT8186 evaluation board to shell.
>
> Applied, thanks!

Based on the review from Angelo I dropped patch 3 from the tree. Please address 
the issues and submit again.

Regards,
Matthias

> > Based on next-20220519, linux-next/master
> >
> > changes since v9:
> >   - remove some merged PATCHs from series
> >   - reorder nodes in dts (cpu-map)
> >   - remove okay status in auxadc
> >   - remove unnecessary suffix node name for i2c
> >   - add pwm node
> >   - add dsi-phy node
> >   - add dpi node
> >
> > changes since v9:
> >   - add one space before equal sign of drive-strength-adv
> >   - corect compatible name for big cores (ca76)
> >   - use upper case of address in pinctrl
> >   - add pwrap node
> >   - add pwm node
> >
> > changes since v8:
> >   - change name from pins_bus to pins-sda-scl
> >   - correct email address
> >   - add capacity-dmips-mhz for each CPU
> >   - add ppi-partitions in gic node
> >   - change name to power-domain
> >   - remove status "okay" in scp node
> >   - update timer and pericfg compatible in series
> >
> > changes since v7:
> >   - add scp&auxadc node
> >
> > changes since v6:
> >   - remove unnecessary blank line
> >
> > changes since v5:
> >   - replace Mediatek a to MediaTek
> >   - use GPL-2.0-only OR BSD-2-Clause
> >
> > changes since v4:
> >   - correct driver clock of mt8186
> >   - add power domains controller and clock controllers
> >   - add pinctrl, usb host, spi and i2c nodes
> >   - add node status in mt8186-evb.dts
> >   - correct some dtbs_check warnings
> >
> > changes since v3:
> >   - remove serial, mmc and phy patch from series. (already merged)
> >   - remove mcusysoff node
> >   - move oscillator nodes at the head of dts
> >   - change name from usb-phy to t-phy
> >
> > changes since v2:
> >   - add soc {} in mt8186.dtsi
> >
> > changes since v1:
> >   - add dt-bindings: arm: Add compatible for MediaTek MT8186
> >
> > Allen-KH Cheng (3):
> >    dt-bindings: arm: mediatek: Add mt8186 pericfg compatible
> >    dt-bindings: arm: Add compatible for MediaTek MT8186
> >    arm64: dts: Add MediaTek SoC MT8186 dts and evaluation board and
> >      Makefile
> >
> >   .../devicetree/bindings/arm/mediatek.yaml     |    4 +
> >   .../arm/mediatek/mediatek,pericfg.yaml        |    1 +
> >   arch/arm64/boot/dts/mediatek/Makefile         |    1 +
> >   arch/arm64/boot/dts/mediatek/mt8186-evb.dts   |  232 ++++
> >   arch/arm64/boot/dts/mediatek/mt8186.dtsi      | 1016 +++++++++++++++++
> >   5 files changed, 1254 insertions(+)
> >   create mode 100644 arch/arm64/boot/dts/mediatek/mt8186-evb.dts
> >   create mode 100644 arch/arm64/boot/dts/mediatek/mt8186.dtsi